User manual PHILIPS AZ127

[. . . ] Battery usage CAUTION – To prevent battery leakage which may result in bodily injury, property damage, or damage to the unit: • Install all batteries correctly, + and - as marked on the unit. • Do not mix batteries (old and new or carbon and alkaline, etc. ). • Remove batteries when the unit is not used for a long time. Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like. • • • • CAUTION: Danger of explosion if battery is incorrectly replaced. [. . . ] When you disconnect the AC power, always pull the plug from the socket. Never pull the cord. 1 2 3 Open the battery compartment. Insert 6 batteries (type: 1. 5V R14/UM2/C CELL) with correct polarity (+/-) as indicated. Close the battery compartment. •• Risk of product damage!Make sure that the power Connect the AC power cord to: • the AC~ MAINS socket on the unit. • the wall socket. Note •• To switch the unit off completely, disconnect the power cord from the power supply socket. EN 5 Turn on Press . »» When the source selector is in the AUDIO-IN/CD position, is displayed. Switch to standby mode • The unit switches to standby mode automatically when there is no audio detected for over 15 minutes. • Press to wake up the unit from standby mode. Turn off Press again. 6 EN 4 Play Play a CD Note •• You cannot play CDs encoded with copyright protection technologies. You can play commercially available audio CDs: • CD-Recordables (CD-R) • CD-Rewritables (CD-RW) Play from an external device You can also listen to an external audio device through this unit. 1 2 3 4 • • • • Switch the source selector to AUDIO-IN/ CD. Insert a CD with the printed side facing up and close the CD lid gently. »» The total number of tracks displays. . 1 2 Switch the source selector to AUDIO-IN/ CD. Connect an audio cable (3. 5mm, not supplied) to: • the AUDIO-IN socket on the unit. • the headphone socket on an external device. Play the external device (see the device's user manual). Note To select a track, press To pause CD play, press »» [ ] flashes. To resume CD play, press To stop CD play, press . 3 again. •• The AUDIO-IN socket is not for headphones. •• The display panel lights off when the unit plays from the external device. Audio-in EN 7 Play tape 1 2 3 4 Slide the source selector to TAPE. on main unit to open the tape Load the tape with the open side upward and the full spool to the right. • To pause/resume play, press on main unit . • To rewind or fast-forward, press / on main unit . [. . . ] • Ensure that there is power at the AC Mains. • Ensure that the batteries are inserted correctly. No sound or poor sound •• Adjust the volume. No response from the unit •• Disconnect and reconnect the AC power plug, then turn on the system again. [. . . ]