User manual PHILIPS CC 5060

[. . . ] Recharge the appliance as soon as the motor starts to run more slowly. Charging the appliance Charge the appliance for at least 8 hours before you use it for the first time and after a long period of disuse or when the battery light turns orange to indicate that the battery is almost empty. 2 Insert the appliance plug into the appliance and put the adapter in the wall socket (Fig. , After a few seconds, the battery light starts flashing green to indicate that the appliance is charging (Fig. [. . . ] This means that, if you use the clipper without the comb, the hair is cut off very close to the skin. 1 Press and hold the setting selector (1) with one hand and pull the comb off the appliance (2) with your other hand (Fig. 2 Before you start to contour the hairline round the ears, comb the hair ends over the ears. 3 Tilt the appliance in such a way that only one edge of the cutting element touches the hair ends. the hairline has to be close to the ear. 5 To contour the neckline and sideburns, turn the appliance and make downward strokes. Graduation The Philips hair clipper not only allows you to cut the hair evenly at the same length all over the head, it also enables you to achieve a smooth transition from longer hair on top of the head to shorter hair on the back and sides of the head. 1 Slide the large comb into the guiding grooves of the appliance (`click') (Fig. 3 Then choose a shorter setting and cut the hair on all parts of the head, except for the top, where you want the hair to be longer. 4 Repeat this procedure until all hairs have the desired length. Cutting over styling comb or fingers This technique can be used to obtain hair lengths over 42mm. Bear in mind that this technique is difficult to master and should only be applied by experienced users. 1 Press and hold the setting selector (1) with one hand and pull the comb off the appliance (2) with your other hand (Fig. 3 Lift the hair with the styling comb and hold it between your fingers until only the length that needs to be cut sticks out. 4 Cut the hair protruding from the comb or fingers. 5 Continue this procedure and comb frequently to remove cut hair and to check for unevenly cut sections. Cleaning Clean the appliance every time you have used it. Important Read this user manual carefully before you use the appliance and save it for future reference. Danger Make sure the adapter does not get wet. This appliance and its accessories (cape, scissors, brush, combs and pouch) are NOT toys. If the appliance is used on young children's hair, it must be operated by a responsible adult. Keep the appliance and its accessories out of the reach of young children. [. . . ] 1 Disconnect the appliance from the mains and let the appliance run until the motor stops. 2 Push the middle part of the cutting unit upwards with your thumb until it opens (Fig. 3 Undo the two screws in the hair chamber (Fig. 4 Use both hands to separate the front part of the housing from the back part and remove the front part of the housing (Fig. [. . . ]