User manual PHILIPS CID3711

[. . . ] Register your product and get support at www. philips. com/welcome CID3711 User manual 3 37 Contents 1 Important Safety Notice 4 4 4 6 6 6 7 8 8 11 11 13 13 13 13 14 14 14 16 16 17 17 17 18 19 19 19 19 20 20 20 21 21 22 8 Play iPod/iPhone Compatible iPod/iPhone Listen to the iPod/iPhone Charge the iPod/iPhone 23 23 23 23 24 24 24 24 24 24 25 25 25 26 27 27 28 28 28 30 30 30 30 30 31 31 31 32 33 33 33 34 34 9 Adjust sound Adjust volume Mute Select preset equalizer Turn FullSound on/off Turn DBB on/off 2 Your in-car entertainment system Introduction What's in the box Overview of the main unit 3 Get started Install the car audio Turn on Set date and time 10 Adjust settings Display system setup menu Adjust general settings Adjust sound settings Adjust video settings Adjust Bluetooth settings Adjust volume settings Adjust language settings Adjust DVD rating 4 Play audio/video/picture Load discs Connect USB device Insert SD/MMC card Play/pause Browse Video options Audio options View photo 11 Others Adjust brightness Set rear view camera Allocate Steering Wheel Control Play from rear displays Listen to other devices Reset Replace fuse 5 Listen to radio Tune to a radio station Store radio stations in memory Tune to a preset station 12 Product information Supported video formats USB playability information Supported MP3 disc format 6 Use navigation system Insert map card Use map Upgrade the map 13 Troubleshooting About the Bluetooth device 7 Play with Bluetooth device Pair the Bluetooth-enabled devices Make a call Receive call Adjust Bluetooth settings Listen to music from Bluetooth device EN 3 English 1 Important Safety Read and understand all instructions before you use the apparatus. If damage is caused by failure to follow instructions, the warranty does not apply. Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. The device is designed for negative ground (earth) 12 V DC operation only. [. . . ] » Navigation routine data will be transferred to your GPS system and your car audio will switch to navigation mode automatically. Use map Note You might need to upgrade the navigation map (sold separately) before using it. See "Upgrade the map" section Upgrade the map 1 2 3 4 5 6 Exit navigation system. Press on the map card until you hear a click sound. Pull out the map card and bring it to the authorized service center for upgrade. Insert the upgraded map card back into the card slot. » The map upgrades in a few minutes. 1 2 3 Tap the upper left corner to display main menu. » The navigation menu is displayed in a few seconds. Refer to the user manual of the navigation map to operate the navigation tool. EN 19 English 6 Use navigation system Connect to GPS call center (Optional) 7 Play with Bluetooth device You can make or receive phone calls with Bluetooth-enabled phones through the unit. You can also listen to music from a Bluetoothenabled device. 4 Enter default password "0000". » If the pairing succeeds, the phone call record is displayed. Disconnect Bluetooth devices Pair the Bluetooth-enabled devices To connect your Bluetooth device to the unit, you need to pair the device to the unit. You can pair up to eight devices. Note The operational range between this unit and a Bluetooth device is approximately 10 meters (30 feet). Turn on the Bluetooth function on the device. Before you connect a Bluetooth device to this unit, familiarize yourself with the Bluetooth capabilities of the device. Compatibility with all Bluetooth devices is not guaranteed. Any obstacle between this unit and a Bluetooth device can reduce the operational range. Keep this unit away from any other electronic device that may cause interference. The device will also be disconnected when the device is moved beyond the operational range. If you want to reconnect the device to the unit, place it within the operational range. Tip If you do not want to reconnect the device to the unit automatically, tap >[Auto connect], then select [Off]. For details, see the "Adjust Bluetooth settings" section. Make a call 1 2 3 Pair the phone with the unit. » List of available Bluetooth devices is displayed. 1 2 3 Turn on the Bluetooth function on the device. Search for Bluetooth device with the device. Select "CID3711" in the pairing list. 20 EN 4 By default, all incoming calls are received automatically. Note You can select to receive calls manually by set [Auto answer] to [Off] status. For details, refer to "Adjust Bluetooth settings". 5 Tap , , or to select a phone number. [. . . ] If you encounter problems when using this device, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site (www. When you contact Philips, ensure that the device is nearby and the model number and serial number are available. No power Car engine has not been started. [. . . ]