User manual PHILIPS CMD305A/12 QUICK STARTING GUIDE

[. . . ] 3) Nota Emparejamiento de un dispositivo Nota • • • • • Make sure that the width of your phone is between 52 mm and 73 mm. Before docking your phone, make sure that the dock bracket is in portrait position. 5 Listen to radio Select a radio region You can select a radio region that matches your location. » 1 Check the car’s wiring carefully, and then connect them to the ISO male connector. [. . . ] Wma files that are copied onto a compatible USB storage device. Note To use the hands-free function or play audio through the dock, connect your phone with the car audio system via Bluetooth first. To enjoy the latest features, update the application on your phone when an update message prompts. After update, the interface and features may be different from the description in this section. 1 2 1 2 4 Red wire Run the CarStudio application on your phone. € To switch the interface for more features, swipe on the screen. Charge your phone Once your phone is connected and recognized, the charging starts. € • 5 6 7 8 Green and green/ Left speaker (rear) black wires White and white/ Left speaker (front) black wires Gray and gray/ black wires Purple and purple/black wires Right speaker (front) Right speaker (rear) Philips does not guarantee compatibility with all USB storage devices. 1 2 If play does not start automatically, 1 Press / to select a folder. » Connect the USB storage device to the socket. 2 Connect the ISO male connector and other wires to the car audio system. 2-2) Connector or socket Connects to Antenna for radio An external microphone for phone call Subwoofer Rear right speaker OE remote Front left speaker Front right speaker 7 Listen to an external device (Fig. 7) With this car audio system, you can listen to audio from a player or make a call through Bluetooth. 2) Hinweis • • • • • • Tip • The pin arrangement for the ISO connectors depends on the type of vehicle you drive. Be sure to make proper connections to prevent damage to the system. Philips does not guarantee the compatibility with all Bluetooth devices. Before pairing a device with this system, read its user manual for Bluetooth compatibility. Make sure that the Bluetooth firmware version of the device is V2. Make sure that Bluetooth function is enabled on your device, and your device is set as visible to all other Bluetooth devices. The operational range between this system and a Bluetooth device is approximately 3 meters (10 feet). Any obstacle between this system and a Bluetooth device can reduce the operational range. Keep away from any other electronic device that may cause interference. [. . . ] Sie 3 4 5 6 Place the supplied rubber cushion over the end of the mounting bolt. 3 - 3) Slide the system into the dashboard until you hear a “click”. 3 - 5) Reconnect the negative terminal of the car battery. Hinweis 6 7 • Make sure that the internet connection is active on your phone. [. . . ]