User manual PHILIPS DS3400

[. . . ] Do not mix batteries (old and new or carbon and alkaline, etc. ). Remove batteries when the unit is not used for a long time. Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like. • • • • Apparatus shall not be exposed to dripping or splashing. [. . . ] • the wall socket. Turn on Press to turn the docking speaker on. »» The / LED indicators light up. DC IN Switch to standby mode The docking speaker switches to standby mode in the following situation: • Press again; • The speaker is idle for 15 minutes when powered by AC supply. »» The / LED indicators light off. 5 EN 4 Play Play from iPod/iPhone You can enjoy audio from your iPod/iPhone through this docking speaker. 6 7 Launch the app after the installation. »» Audio comes out through this docking speaker. Note Compatible iPod/iPhone The docking speaker supports the following iPod and iPhone models: Made for. • iPod touch (5th generation) • iPod nano (7th generation) • iPhone 5 •• With the ClockStudio app, you can enjoy radio, set clock and alarm, adjust sound settings, and update firmware if necessary. Listen to the iPod/iPhone To enjoy more features, you are recommended to install the free ClockStudio app. Update firmware If firmware update is available, the ClockStudio app will search for it automatically and ask you to download it. Note •• Make sure that your iPod/iPhone is inserted in the docking speaker and connected to the Internet. 1 2 Press to turn the docking speaker on. »» The LED indicators light up. Insert the iPod/iPhone into the dock. 1 If a new firmware update is found, tap OK. 3 4 5 For first-time use, you will be asked to install ClockStudio app on your iPod/ iPhone. Tap [Yes] (yes) to accept the installation request. Follow the on-screen instructions to complete the installation. EN 6 2 Follow the on-screen instructions to complete the firmware update. Note •• Do not disconnect power or undock the iPod/iPhone during the updating process. Charge the iPod/iPhone Note •• If the docking speaker is operated on the batteries, you cannot charge your iPod/iPhone. When the docking speaker is connected to AC power, the docked iPod/iPhone begins to charge. Sync iPod/iPhone with PC Note •• Make sure that iTunes has been configured properly in your PC. 7 EN 1 2 3 4 Insert the iPod/iPhone in the dock. »» The LED indicators light off. Connect your docking speaker and PC with a USB cable. Launch iTunes to synchronize your docking speaker with PC. »» The docked iPod/iPhone is synchronized with PC successfully through the iTunes. Note Adjust volume To adjust volume: • Press +/- on your docking speaker; or • Adjust the volume control of your iPod/iPhone or external device. •• Due to different materials and product techniques, some USB cables may not work with this device.   Play from an external device With this docking speaker, you can also enjoy audio from an external device such as an MP3 player. Note •• Make sure that there is no audio detected from docking connector in the speaker. Tip •• If the docking speaker is powered by batteries, the volume is lower than that by AC supply. 1 2 Press to turn the docking speaker on. 3 Connect the MP3 link cable (not supplied) to: • the AUDIO-IN socket at the back of the docking speaker. • the headphone socket on an external device. [. . . ] Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards. Please note that the use of this accessory with iPod or iPhone may affect wireless performance. iPod and iPhone are trademarks of Apple Inc. , registered in the U. S. [. . . ]