User manual PHILIPS FC8146/01

[. . . ] Register your product and get support at www. νικα 42 Suomi 55 Français 67 Italiano 79 Nederlands 91 Español 103 Norsk 115 Português 127 Svenska 139 Türkçe 151 FC8148 - FC8140 6 English Introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. €1) 1 Cover 2 On/off button 3 Dust container full indicator 4 Electronic suction power control 5 Cord rewind button 6 Rear wheel 7 Hose connector 8 Hose connection opening 9 Cover release tab 10 Handle 11 Filter cone 12 HEPA dust container filter 13 Foam filter 14 Dust container handle 15 Dust container 16 Cover latch 17 Bottom cover of dust container 18 Motor protection filter 19 Swivel wheel 20 Type plate 21 Storage slot 22 HEPA exhaust filter 23 Rocker switch for carpet/hard floor settings 24 Combination nozzle 25 Parking slot 26 Mains cord with plug 27 Exhaust filter grille 28 Crevice nozzle 29 Small nozzle 30 Telescopic tube 31 Hard floor nozzle (specific types only) 32 Small brush 33 Accessory holder 34 Hose with handgrip and suction power slide 35 Mini turbo brush (specific types only) Important Read this user manual carefully before you use the appliance and save it for future reference. [. . . ] 1 Clean the appliance with a damp cloth. 12 English Emptying the dust container -- For optimal performance,  empty the dust container and clean the filter cone, the HEPA dust container filter and the foam filter when the dust container full indicator goes on. 1 Disconnect the hose from the appliance. 3 Lift the dust container out of the appliance by its handle. 4 Hold the dust container over a dustbin and push down the cover latch (1) to open the bottom cover of the dust container (2). 5 Empty the dust container into a dustbin. English 6 To remove the filter cone, turn it anticlockwise in the direction marked by the arrow and lift it out of the dust container. 13 7 To clean the filter cone, tap it gently against the side of a dustbin. 8 Put the filter cone back into the dust container and turn it clockwise in the direction marked by the arrow to lock it in place (‘click’). 9 Close the bottom cover of the dust container and lock it by pushing it home behind the cover latch (‘click’). 10 Pull the latch of the HEPA dust container filter to open it. , , The spring-loaded button on the dust container pushes the filter out of the hinges. 11 Rinse the pleated side of the HEPA dust container filter under a hot slow-running tap. 14 English -- Hold the filter in such a way that the pleated side points upwards and the water flows parallel to the pleats. Hold the filter at an angle so that the water washes away the dirt inside the pleats. -- Turn the filter 180° and let the water flow along the pleats in the opposite direction. -- Continue this process until the filter is clean. Never clean the HEPA filter with a brush. Note: Cleaning does not restore the original colour of the filter, but does restore its filtration power. 12 Remove the foam filter and rinse it under a tap. 13 Carefully shake the water from the surface of the HEPA dust container filter. Let the HEPA dust container filter and the foam filter dry completely before you put them back into the vacuum cleaner. [. . . ] 2 Press the cord rewind button to rewind the cord. 3 Put the appliance in upright position. To attach the nozzle to the appliance,  insert the ridge on the nozzle into the storage slot. Note:To ensure stable storage of the telescopic tube, adjust the tube to the shortest length. [. . . ]