User manual PHILIPS FC9130

[. . . ] Preparing for use Connecting accessories Hose 1 To connect the hose, push it firmly into the appliance ('click'). 2 To disconnect the hose, push the buttons on the swivel and pull the hose out of the appliance (fig. Depending on the type, this appliance is equipped with one of them. see the systems displayed in the following pictures. [. . . ] 6 Re-insert the cartridge into the holder ('click'). It only fits into the holder in one way (fig. Replace the granules when the cartridge no longer emits any fragrance. Setting the amount of fragrance 1 You can set the amount of fragrance by turning the cartridge forwards (maximum emission) and backwards (minimum emission) (fig. 2 When you store the vacuum cleaner or don't want any fragrance to be emitted, close the cartridge by turning it backwards until the openings of the cartridge are no longer visible. Using the appliance Adjusting suction power 1 You can adjust the suction power, while vacuum cleaning, with the slide control on top of the appliance (fig. 2 Use maximum suction power for vacuum cleaning very dirty carpets and hard floors. Make sure the - and + poles are pointing in the right direction. With the infrared remote control you can set the suction power to one of 5 different suction power settings. When you switch the appliance on, it will always start running at the highest suction power setting. 2 By pushing the - button, you will reduce the suction power by one setting (fig. 3 By pushing the + button, you will increase the suction power by one setting (fig. 4 Push the standby button to temporarily switch the vacuum cleaner off, for instance when you have to move some furniture (fig. Parking the tube 1 By inserting the ridge on the nozzle into the parking slot, you can park the tube in a convenient position (fig. Storage 1 You can put the appliance in upright position and attach the nozzle to the appliance by inserting the ridge on the nozzle into the slot (fig. 2 Always put the Tri-Active nozzle in carpet setting when you store it and prevent the side brushes from becoming bent. Replacement The dustbag 1 Replace the dustbag as soon as the dustbag-full indicator changes colour (fig. The dustbag is full when the colour of the indicator has changed when the nozzle is not placed on the floor. Place your fingers at the front of the cover and press with your thumb on the ridge on top of the cover. Make sure you hold the dustbag upright when lifting it out of the appliance. When you do this, the dustbag will be automatically sealed. 6 Slide the cardboard of the new dustbag into the two grooves of the dustbag holder as far as possible. [. . . ] Com or contact the Philips Customer Care Centre in your country (you will find its phone number in the worldwide guarantee leaflet). If there is no Customer Care Centre in your country, turn to your local Philips dealer or contact the Service Department of Philips Domestic Appliances and Personal Care BV. Troubleshooting guide The suction power is insufficient: 1 Check if the suction power control is in the required position (see 'Using the appliance'). Switch the vacuum cleaner on to make the airflow suck the obstructing material out of the blocked-up item (fig. [. . . ]