User manual PHILIPS FR966-00S

[. . . ] if the mains plug contains a fuse , this should have a value of 5 Amp. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5 Amp. Note: The severed plug must be disposed of to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere. The wires in the mains lead are coloured with the following code: blue = neutral (N), brown = live (L). [. . . ] Therefore your set may disconnect under extreme conditions. If this happens, switch the set off and let it cool down before reusing it. The receiver switches to STEREO and surround sound will be reduced to a stereo signal which is reproducible by standard headphones. disconnecting the headphones switches on the speakers again. If you wish to enjoy surround sound again, switch the receiver back to surround sound. Clean the receiver with a soft, slightly dampened, lint-free cloth. Do not use any cleaning agents as they may have a corrosive effect. Do not expose the receiver to humidity, rain, sand or excessive heat (caused by heating equipment or direct sunlight). The display of the receiver is divided into 4 sections, which are to be used for the following: Speaker diagram Signs showing you various settings and information about the status of the receiver. An RDS station with EON is being received. Analogue input is being used for the playing source. * SPEAKR SETUP Selects the used speakers. SUBW PRESENT Subwoofer present: yes/no CENTER SPEAKR Center speaker present: yes/no REAR SPEAKER Rear speakers present: yes/no * SPEAKR SIZES Chooses the speaker sizes of the used speakers, for optimal sound reproduction. LARGE indicates a speaker which can reproduce frequencies lower than 50 Hz. if SUBW PRESENT is set to NO , FRONT SIZE can only be set to LARGE. If FRONT SIZE is set to SMALL, CENTER SIZE can only be set to SMALL and consequently a subwoofer must be connected. therefore the SURROUND ON/OFF , HALL and SURR. MODE button have no effect since the provided signal is already multichannel. From a source which is connected to the 6 CHANNEL / DVD INPUT audio input cannot be recorded. To change this, the source selection must be reassigned to another audio input. 3 Turn X MENU NAVIGATOR to select the input connectors which should be used (e. If you wish to record from a source you must select it with SOURCE SELECT. [. . . ] Y While news or traffic information is being broadcast the receiver will switch to tuner and NEWS or TA will flash. 4 Press NEWS/TA until the display indication disappears to switch off the function(s). Or Press NEWS/TA during an announcement to switch off the function(s). Note: Be sure to switch the news and traffic announcement off during recording, otherwise these announcements also will be recorded. [. . . ]