User manual PHILIPS FW730C

[. . . ] If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. If the mains plug contains a fuse, this should have a value of 5 Amp. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5 Amp. Note: The severed plug must be disposed of to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere. [. . . ] 3 Press the CD (CD 1·2·3) button to select the disc. 4 Press PREV í or NEXT ë to select the desired track. · Repeat steps 3 to 5 to store other discs and tracks. 6 Press STOP·CLEAR Ç once to end programming. TM The total number of tracks programmed and total playing time appear on the display. ­ During programming, if no button is pressed within 20 seconds, the system will exit program mode automatically. Reviewing the program Reviewing of the program is possible only when playback is stopped. · Press PREV í or NEXT ë repeatedly to review the programmed tracks. · Press STOP·CLEAR Ç to exit review mode. Notes: ­ If you press any of the CD DIRECT PLAY buttons, the system will play the selected disc or track and the stored program will be ignored temporarily. The PROGRAM flag also will disappear temporarily from the display. It will reappear when playback of the selected disc ends. ­ REPEAT DISC mode will be cancelled when program playback begins. English 16 Playing the program 1 Press PLAY É to start program playback. TM "PLAY PROGRAM" appears on the display. 2 Press REPEAT until the "OFF" mode is displayed to resume normal playback. TM The REPEAT flag disappears from the display. MINI HIFI SYSTEM PROGRAM SHUFFLE REPEAT TIMER REC NEWS T. A. AM MW FM LW 60Hz 250Hz 500Hz 1KHz 2KHz 4KHz 8KHz STEREO BACK FRONT HSD C C L L R R PRO LOGIC PRO LOGIC STANDBY ON CLOCK/ TIMER S S S S DOLBY B NR RDS NEWS! CD1 · 2 · 3 CD PROG SEARCH · TUNING BAND TUNER TAPE 1 · 2 TAPE v VIDEO AUX PRESET v PREV NEXT STOP · CLEAR PLAY PAUSE UP SOUND NAVIGATION DOWN VOLUME DIGITAL SOUND CONTROL DYNAMIC BASS BOOST Note: ­ For 'EASY SET' feature, please refer to page 11. Note: ­ REPEAT DISC mode will be cancelled when shuffle is selected. Notes: ­ REPEAT DISC mode is not available during program play or shuffling mode. ­ You can also repeat shuffling a program. TM "REPEAT TRACK" or "REPEAT PROGRAM" will be displayed. TM The REPEAT, PROGRAM and SHUFFLE flags appear on the display. Tuning to radio stations 1 Press TUNER (BAND) to select TUNER mode. A few seconds later, the current radio frequency will be displayed. 2 Press TUNER (BAND) again to select the desired waveband : FM, MW or LW. 3 Press TUNING à or á for more than one second, then release. TM The display will show "SEARCH" until a radio station with sufficient signal strength is found. · Repeat this procedure until the desired station is reached. · To tune to a weak station, briefly press TUNING à or á repeatedly until the display shows the desired frequency and/or when the best reception has been obtained. English 17 Repeat (only on remote control) TUNER Storing Preset Stations You can store up to 40 radio stations in the memory. [. . . ] · Tape dubbing is only possible in tape mode. TM Switch to tape mode by pressing TAPE. Recording or playback cannot occur or there is a decrease in audio level. · Dirty tape heads, capstans or pressure rollers. [. . . ]