User manual PHILIPS GC-4410

[. . . ] Always here to help you Register your product and get support at www. Com/welcome GC4400 series User manual 1 English 6 Español 13 Français 21 Italiano 29 Português 37 51 58 GC4400 series 6 English Introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. €1) Spray nozzle Cap of filling opening Steam boost Spray button Steam control Ionic DeepSteam button (specific types only) Ionic DeepSteam light (specific types only) Temperature dial Specific types only: Amber temperature light with (specific types only) red automatic shut-off (AUTO/OFF) indication. [. . . ] However, ironing at low temperatures without steam with the Ionic DeepSteam function switched on will not damage the iron. Note:The Ionic DeepSteam output may vary from time to time, depending on the ironing temperature. Ironing without steam 1 Set the steam control to position 0 (= no steam) (Fig. Do not use the Ionic DeepSteam function, as this function has no effect when you iron without steam. 2 Set the required ironing temperature (see chapter ‘Preparing for use’, section ‘Setting the temperature’). English After ironing 1 Remove the mains plug from the wall socket. 2 If you have been steam ironing, empty the water tank. 3 Let the iron cool down in a safe place. Features Spray function You can use the spray function at any temperature to moisten the article to be ironed. 1 Make sure that there is enough water in the water tank. 2 Press the spray button several times to moisten the article to be ironed (Fig. The steam boost enhances the distribution of steam into every part of your garment. The steam boost function can only be used at temperature settings between 3 and MAX. Vertical steam boost 9 1 You can also use the steam boost function when you hold the iron in vertical position. €12) This is useful for removing creases from hanging clothes, curtains etc. Drip stop This iron is equipped with a drip-stop function: the iron automatically stops producing steam when the temperature is too low, to prevent water from dripping out of the soleplate. When this happens, you may hear a sound. Automatic shut-off function (specific types only) The automatic shut-off function automatically switches off the iron if it has not been moved for a while. , , The red AUTO/OFF indication of the temperature light flashes to indicate that the iron has been switched off by the automatic shut-off function. To let the iron heat up again: 1 Pick up the iron or move it slightly. , , The red AUTO/OFF indication goes out. , , If the temperature of the soleplate has dropped below the set ironing temperature, the amber temperature light goes on. [. . . ] Repeat the Calc-Clean process if the iron still contains a lot of impurities. After the Calc-Clean process 1 Put the plug back into the wall socket and let the iron heat up to let the soleplate dry. 2 Unplug the iron when it has reached the set ironing temperature. 3 Move the hot iron gently over a piece of used cloth to remove any water stains that may have formed on the soleplate. [. . . ]