User manual PHILIPS GC6620/20 SPEEDCARE

[. . . ] This takes place regardless of the type of water used. Sound and light Calc-Clean reminder -- After 1 to 3 months of use, the Calc-Clean light starts flashing and the appliance starts beeping to indicate that you have to perform the Calc-Clean process (Fig. -- You can continue steam ironing for 1 hour while the Calc-Clean light flashes and the appliance beeps. After 1 hour, the steam function is automatically disabled. [. . . ] 7 4 Place the Calc-Clean container on the ironing board or any other even, stable surface (Fig. 5 Place the iron stably on the Calc-Clean container. note:The Calc-Clean container has been designed to collect scale particles and hot water during the Calc-Clean process. It is perfectly safe to rest the iron on this container during the entire process. 6 Press and hold the Calc-Clean button for 2 seconds until you hear short beeps (Fig. 7 During the Calc-Clean process, you hear short beeps and a pumping sound. Wait approximately 2 minutes for the appliance to complete the process (Fig. 8 When the Calc-Clean process is completed, the iron stops beeping (Fig. 9 Wipe the iron with a piece of cloth and put it back on the base station (Fig. 10 As the Calc-Clean container becomes hot during the Calc-Clean process, wait approx. 11 Carry the Calc-Clean container to the sink, empty it and store it for future use (Fig. Perform the Calc-Clean process to enable the steam function again (see chapter ‘IMPORTANT - Cleaning and maintenance’). Perform the Calc-Clean process to enable the steam function again (see chapter ‘IMPORTANT - Cleaning and maintenance’). You have not done or have not completed the Calc-Clean process. You have not done or have not completed the Calc-Clean process. The appliance has The safety auto-off function was Set the on/off switch to ‘off ’ position and then to ‘on’ position. This happens automatically when the steam generator has not been used or the steam trigger has not been pressed for more than 15 minutes. eNGLISH Problem The appliance produces a loud pumping sound. Water droplets come out of the soleplate. possible cause The water tank is empty. Solution Fill the water tank with water and press the steam trigger until the pumping sound becomes softer and steam comes out of the soleplate. 9 After the Calc-Clean process, Wipe the soleplate dry with a piece of remaining water may drip out of cloth. [. . . ] You have to perform the Calc-Clean process again (see chapter ‘IMPORTANT - Cleaning and maintenance’). Turn the temperature dial to the desired temperature setting instead of CÁLC CLEAN. Let the iron heat up until the ‘iron ready’ light lights up steadily. see chapter ‘IMPORTANT - Cleaning and maintenance’. [. . . ]