User manual PHILIPS GC 7530

[. . . ] We hope you will enjoy using this ironing system. Supply hose Soft-touch handle (GC7240 only) Temperature dial Temperature light Steam activator & lock E1 Steam activator E2 Steam lock Steam boost button (GC7240 only) Soleplate Safe storage lock (GC7240 only) Filling funnel lid Filling funnel Iron stand Water tank Steam tank On/off switch (GC7320/GC 7530 only) On/off button with power-on light (GC7330/GC7240/GC7230 only) `Water tank empty' light (GC7330/GC7240/GC7230 only) Steam setting selector (GC7330/GC7240/GC7230 only) Steam lights (GC7330/GC7240/GC7230 only) Mains cord Calc-Clean rinsing cap Cord storage hook Important Read this user manual carefully before you use the appliance and save it for future reference. danger Never immerse the iron or the steam tank in water. Warning Check if the voltage indicated on the appliance corresponds to the local mains voltage before you connect the appliance. [. . . ] , The steam tank and the iron soleplate start to heat up. , The iron is hot enough when the temperature light goes out. Note: During ironing, the temperature light goes on from time to time. This sound is normal and indicates that water is pumped into the steam tank. If you have ironed at a high temperature and then set the temperature dial to a lower setting, wait until the temperature light goes on again before you continue ironing. Iron velvet and other fabrics that tend to acquire shiny patches in one direction only (along with the nap) while you apply very little pressure. Do not use steam when you iron coloured silk. Note: Some smoke and particles may come out of the iron when you use it for the first time. This is normal and stops after a short while. note:When you switch on the appliance , the steam tank produces a pumping sound. This sound is normal and indicates that water is being pumped into the steam tank. When the steam tank is ready for steam ironing, the steam light of the selected steam setting stops flashing and is on continuously (Fig. Note: Some water droplets may occasionally come out of the soleplate when you use the steam boost function. To prevent this, always use the steam function before you use the steam boost function. Wipe scale and any other deposits off the soleplate with a damp cloth and a non-abrasive (liquid)cleaner. rinsing the steam tank LettheappliancecooldownsufficientlybeforeyouremovetheCalc-Cleanrinsingcap. Rinse the steam tank once a month or after you have refilled the water tank 10 times. Shake the steam tank well over the sink. 1 Remove the mains plug from the wall socket and let the appliance cool down. - There are handgrips on either side of the steam tank for easy transport (Fig. Do not throw away the appliance with the normal household waste at the end of its life, but hand it in at an official collection point for recycling. By doing this, you help to preserve the environment (Fig. [. . . ] You may have used the steam boost function when you started ironing. First steam iron for a while before you use the steam boost function. It is normal that some water droplets come out of the iron occasionally. Steam condenses in the hose, which causes droplets of water to escape from the soleplate. [. . . ]