User manual PHILIPS HD5702

[. . . ] In this user manual you find all the information you need to optimally enjoy your espresso maker. Important Read this user manual carefully before you use the appliance and save it for future reference. If the mains cord is damaged, you must have it replaced by Philips, a service centre authorised by Philips or similarly qualified persons in order to avoid a hazard. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. [. . . ] Clean all parts thoroughly with hot water and some washing-up liquid or in a dishwasher. Make sure there are no milk residues inside the two holes in the lid of the milk jug. Reattach the milk intake tube and the milk frothing pipe, put the lid on the milk jug and put the milk jug back into the appliance. Changing the coffee and milk quantity for cappuccino or latte macchiato The appliance is preset to dose specific amounts of coffee and milk for cappuccino and latte macchiato. You can change these quantities as follows: 1 Fill the milk jug with milk. Put a cup under the coffee spout and the milk frothing pipe. press the cappuccino button or the latte macchiato button for at least 5 seconds. Release the button when `PROGRAM TO SET VOL. , After a few seconds, milk starts to come out the milk frothing pipe. 5 When the milk in the cup reaches the required level, press the same button again to set the new quantity. , After a few seconds, the appliance starts to brew coffee and `PROGRAM TO SET VOL. Note: If the descaling program is interrupted before completion, the appliance continues to display the message `PLEASE DESCALE!' and you have to start the program from the beginning again. Press the ^ or % button until the desired coffee temperature is displayed (low, medium or high). This function allows you to set a time at which the appliance automatically switches on. 1 Make sure the clock on the appliance is set as described (see section `Setting current time' in this chapter). Note:When you switch off the appliance while an auto-on time is set, the > symbol appears next to the time on the unlit display. Setting auto-off time The appliance is factory preset to switch off automatically one hour after the last cup of coffee is brewed. You can increase this time to 2 hours or 3 hours. Press the ^ or % button to change the number of hours after which the appliance switches off automatically. Dip the strip fully into the tap water you use to brew coffee. Keep the strip in the water for a few seconds. [. . . ] The coffee does not come out of the coffee spout but around the edges of the service door. The spout holes are clogged with dried coffee residues. Thoroughly clean the inside of the appliance. Brew espresso from ground coffee again, but switch on the appliance before you put the ground coffee in the ground coffee compartment. [. . . ]