User manual PHILIPS HD7800

[. . . ] IMPORTANT:YOU CANNOT BREW COFFEE IF YOU HAVE NOT FLUSHED THE APPLIANCE FIRST! 7 C 1 Remove the water reservoir. C 2 Fill the water reservoir with cold water up to the MAX indication and put it back onto the appliance. C 3 Release the lid by moving the two levers towards each other. C 4 Open the lid. 8 ENGLISH C 5 Put the 1-cup or 2-cup pad holder in the appliance without pad(s). C 6 Close the lid again. Make sure the levers return fully to their most outward position by pushing firmly on the lid. 7 Put the plug in an earthed wall socket. C 8 Put a bowl (with a capacity of at least 27 fl. ounce)under the coffee outlet openings to collect the water: C 9 B Press on/off button I and subsequently press buttons ° and °° briefly at the same time. [. . . ] When you switch the appliance back on after having interrupted the brewing process, the appliance will not complete the interrupted brewing cycle. If the appliance stops brewing when you are making two cups of coffee, yet the cups are only half full, there was not enough water left in the water reservoir. Fill the water reservoir and press button ° for one cup. The two cups will then be filled completely. C 11 Remove the coffee pads after use by lifting the pad holder out of the appliance and emptying it. ENGLISH Tip: regular rinsing of the pad holder gives the coffee a better taste. Tip: the coffee will taste best if you stir it before drinking it. 11 C Tip: if you intend to make another cup of coffee later, just leave the appliance switched on. The appliance will automatically switch itself off after 1 hour. Cleaning Never immerse the appliance in water. 1 2 Always unplug the appliance before you start cleaning it. Clean the outside of the appliance with a moist cloth. Remove the coffee outflow unit and clean it with a washing-up brush. C C 3 You can disassemble the coffee outflow unit for more thorough cleaning. C 4 Clean the pad holder, the cup tray and the drip tray in hot water, if necessary with some washing-up liquid, or clean them in the dishwasher. Tip: the pad holders, drip tray, cup tray and coffee outflow unit are dishwasher proof. C Tip: the top of the reservoir can be removed to allow thorough cleaning of the inside. 12 ENGLISH C Clean the water reservoir thoroughly in hot water, if necessary with some washing-up liquid. 5 Rinse the parts with fresh water after cleaning and put them back onto the appliance. Descaling Regular descaling will prolong the life of your appliance and will guarantee optimal brewing results for a long time. C Fill the water reservoir with a descaling agent up to the MAX indication and put the water reservoir back on the appliance. Use a descaling agent based on citric acid. Follow the instructions on the package of the descaling agent. 1 C 2 Put a bowl (with a capacity of at least 27 fl. ounce) under the coffee outlet to collect the descaling agent: C Press on/off button I and subsequently press buttons ° and °° briefly at the same time to start flushing the appliance. For the best result, wait at least 30 minutes after flushing the appliance with the descaling agent. 3 4 5 Repeat this descaling procedure one more time. Let the appliance complete two more flushing cycles with clean water to rinse away any descaling agent residues. Replacing the mains cord If the mains cord of this appliance is damaged, it must always be replaced by Philips or a service centre authorised by Philips, as special tools and/or parts are required. ENGLISH 13 Solving problems If you have a problem, you may find the solution in the table below. If the table does not provide the solution to your problem or if you have a question, see the chapter 'Information & service'. Problem The coffee is not strong enough. Solution Make sure that: - the coffee pad(s) has/have been placed level in the holder. When you are using two coffee pads on top of each other, make sure that the convex sides of both pads are pointing downwards and press the pads slightly down in the pad holder. - you have used the correct number of pads and have pressed the right dosing button. Use 1 pad in combination with the 1-cup pad holder and the ° button. Use 2 pads in combination with the 2-cup pad holder and the °° button. - the coffee is evenly distributed in the coffee pad. If you prefer a more robust flavour, try the Dark Roast blend. Check if you have used the right number of pads and if you have pressed the right dosing button. [. . . ] - the flushing procedure that must be performed before the appliance is used for the first time has been carried out properly. (See the chapter 'Preparing the appliance for use'). - the temperature of the room is above 10cC/42cF. (See the chapter 'Preparing the appliance for use'). [. . . ]