User manual PHILIPS HD7874/60

[. . . ] Indd 4 6/18/12 4:54 PM 1 2 3 4 5 6 7 8 9 Introduction General description Important 5 5 6 6 9 13 14 17 17 17 17 18 Flushing the machine before first use Brewing SENSEO® coffee Cleaning Descaling Frost-free storage Ordering accessories 10 Environment 11 Guarantee and service 12 Troubleshooting 2 General description (Fig. 1) 1 Coffee collector 2 Lid lever 3 Lid with brewing chamber 4 Sealing ring 5 Water distribution disc 6 2-cup pod holder qq 7 1-cup pod holder q  8 Coffee spout cover 9 Coffee spout 10 Spout release buttons 11 Removable drip tray 12 Cup tray 13 Touch panel 14 On/off button 15 Personal coffee memory symbol (HD7872 only) 16 Regular coffee symbol 17 Selection button 18 Strong coffee symbol 19 CALC light 20 1-cup button q 21 2-cup button qq 22 Water reservoir 23 Water reservoir lid 5 1 Introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. Make your coffee moments truly special with SENSEO®. [. . . ] You find its contact details in the worldwide guarantee leaflet. 1 SENSEO® coffee machine This chapter summarises the most common problems you could encounter with the machine. € If you are unable to solve the problem with the information below, visit www. Com/support for a list of frequently asked questions or contact the Consumer Care Centre in your country. Problem My cup overflowed when I used the machine for the first time. Solution You probably tried to brew a cup of coffee without flushing the machine first. Before you start brewing coffee, you have to flush the machine. When you switch on the machine again, the on/off button either lights up continuously or flashes slowly or rapidly. If the on/off button lights up continuously, you have to carry out the flushing procedure (see chapter ‘Flushing the machine before first use’). If the on/off button flashes slowly or rapidly, you do NOT have to carry out the flushing procedure. If the on/off button flashes slowly, the water is heating up. If it flashes rapidly, there is not enough water in the water reservoir or the water reservoir is not placed on the machine properly. If water continued to flow from the spout until the water reservoir was empty, the machine was performing the flushing cycle. Before you start brewing coffee, you have to flush the machine. When you switch on the machine again, the on/off button either lights up continuously or flashes slowly or rapidly. If the on/off button lights up continuously, you have to carry out the flushing procedure (see chapter ‘Flushing the machine before first use’). If the on/off button flashes slowly or rapidly, you do NOT have to carry out the flushing procedure. If the on/off button flashes slowly, the water is heating up. If it flashes rapidly, there is not enough water in the water reservoir or the water reservoir is not placed on the machine properly. You have used the SENSEO® coffee machine at an altitude higher than 2200 metres above sea level. Switch off the machine and no longer use it at altitudes higher than 2200 metres above sea level. You have pressed the 1-cup button and the 2-cup button at the same time. [. . . ] The light in the button flashes but the appliance does not operate. You just prepared hot frothed milk or hot milk and pressed the button for milk or hot frothed milk again straightaway without letting the appliance cool down. The temperature of the milk is too high. You have not placed the lid properly on the appliance. [. . . ]