User manual PHILIPS HF3480

[. . . ] Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. The Philips Wake-up Light helps you wake up more pleasantly. The light intensity of the lamp gradually increases to the set level in the 30 minutes before the set wake-up time. [. . . ] You can choose a light intensity between 1 and 20. This is normal, the lamp needs to heat up. Note:The light intensity you have selected is automatically set as the light intensity level for the alarm as well. Tip:When you use the appliance for the first time, set the light intensity to 20. The moment you wake up, check which light intensity level the appliance has reached by slightly moving the top function selector up or down. When you do this, the current alarm light intensity level appears on the display. Set the alarm light intensity to this level for the next day. 2 To switch off the lamp , press the top function selector again. Note:When you want to check the light intensity without switching on the lamp, you can also move the top function selector up or down to select a setting without pressing the function selector first. Setting the alarm When you set the alarm, you choose an alarm time and the type of sound you want to wake up to. the alarm is set when the alarm symbol is visible on the display. The light intensity slowly increases to the selected level during the last 30 minutes before the set alarm time. The sound slowly increases in 90 seconds to the selected level after the set alarm time. Note:You can set the light intensity by turning the top function selector up or down and you can set the alarm volume by moving the bottom function selector up or down. If you do not want to wake up to the lamp or to a sound, select a light intensity or volume level of 0. see sections `Using the lamp' and `Radio/ Volume' in this chapter. 1 Push the control lever down to the middle position to switch on the alarm. If the alarm time is correct, just wait a few seconds. 2 Move the middle function selector (SET) up or down to select the hour. Note:You can only do this when the hour indication flashes. If this is not the case, push the control lever up and down again to enter the alarm time mode. you can also set the alarm time in the menu. [. . . ] Perhaps you switched off the alarm function by setting the control lever to the top position. If you selected the radio as the alarm sound, the radio may be defective. Switch on the radio after you switch off the alarm to check if the radio works. If it does not work, contact the Philips Consumer Care Centre in your country. [. . . ]