User manual PHILIPS HR-2006

[. . . ] Register your product and get support at Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. Important Read this user manual carefully before you use the appliance and save it for future reference. Noise level: Lc = 86 dB(A) general Danger Never immerse the motor unit in water or any other liquid, nor rinse it under the tap. [. . . ] Screw the blade unit clockwise onto the bottom of the blender jar (2) until the blade unit it is fixed properly. 3) 3 Put the blender jar with the blade unit attached on the motor unit and fix it by turning it clockwise (`click'). 4) The blender jar can be mounted in two positions: with the handle on the right side or on the left side. 3 Insert the measuring cup into the opening in the lid. Turn the control knob to the pulse setting if you want to process ingredients very briefly. Do not let the appliance run for more than 3 minutes at a time. Always let the appliance cool down to room temperature after each batch you process. Tips If you want to crush ice cubes, put not more than 6 ice cubes (of approx. Then turn the control knob to pulse position a few times. Cut meat or other solid ingredients into smaller pieces before putting them in the blender jar. Do not process a large quantity of solid ingredients at the same time. To get good results, we advise you to process these ingredients in a series of small batches. To make tomato juice, cut the tomatoes in four and drop the pieces through the opening in the lid onto the rotating blades. Disassembling the blender 1 Remove the mains plug from the wall socket. 2 Remove the lid with the measuring cup from the blender jar. 3 Turn the blender jar with the blade unit attached anticlockwise to remove it from the motor unit. 4 Clean all removable parts immediately after use (see chapter `Cleaning'). With the filter you can make delicious fresh fruit juices, cocktails or soy milk. The filter prevents pips and skins from ending up in your drink. Do not put more than 70g soy beans (unsoaked weight) or 150g fruit in the filter at the same time. Preparing the filter for use 1 Mount the blender jar with the blade unit attached on the motor unit and fix it by turning it clockwise (`click') (Fig. The blender jar can be mounted in two positions: with the handle on the right side or on the left side. [. . . ] If there is no Customer Care Centre in your country, go to your local Philips dealer. Recipes soy milk Note:This recipe can only be prepared with the filter. Always let the appliance cool down to room temperature after each batch you process. Ingredients 70g dried soy beans 600ml water 1 Soak the soy beans for 4 hours before you process them. [. . . ]