User manual PHILIPS NT9105

[. . . ] Your remote automatically times out if the buttons are depressed more than 30 seconds. This will save your batteries should your remote get stuck in a place where the buttons remain depressed (e. SAT/DBS and CD/Audio are dedicated to their modes. You can either setup the remote using the code for your brand of product, from the code tables, or you can search through the library of codes until you find a code that works for your pro duct. [. . . ] For some brands of VCRs, you might need to press the REC button once, then press it again for three seconds. Info/Select button brings up DVD Display or Control Menu for Chapter/Track/Title number, Time remaining/elapsed indication, system information, etc. Menu brings up the DVD disc Menu screen - use with the Up, Down, Left & Right navigation buttons. Quit button is used to Exit or Clear on-screen Menu displays. Play button is used to start Disc playback and for Menu selection on some DVD players. The 6 VCR keys (Play, Pause, Stop, Record, FF and Rewind) will punchthrough to the device programmed under VCR when in either TV or Cable Modes. SELECT means same as OKAY - some manufacturers use OKAY label and others use SELECT label on their remotes. Use PIP to activate the feature and TOGGLE to swap between the displayed pictures on your TV. TV/VCR and TV/DVD Combo units Note that for some TV/VCR and TV/DVD combo units you might need to set up two different buttons to control both parts of the combo unit. , (referring to the Direct Code Entry section on the following page) you might need to set up a code under the TV button to control the TV part of the combo unit AND a separate code for the VCR or DVD under any other button you choose. Chapter+ and Chapter- buttons perform the "Page+" and "Page-" function for on-screen Guide Menus used by some Satellite systems. This feature works even if your TV does not have this feature. Press and hold the Sleep button until LED remains on (occurring after approx. Press and release the numeric keys (01-99) for the time required. The LED will blink off to indicate keypress acceptance and remain off after second keypress. Leave the Remote pointing towards the TV with an unobstructed path. To cancel the Sleep Timer, press and hold the Sleep key until the LED blinks or press and release the Power key in TV Mode. To find the first digit for the code stored under the mode key pressed in step 2, press each numeric key from 0-9 in turn. When the indicator light blinks off the number you pressed is the first digit for the code you are searching for. To find the second digit, repeat step 4, this time when the indicator light blinks off this is the second digit. Repeat step 4 again to find the third digit. Use fresh batteries for both the Learning Remote and the Original Remote. [. . . ] (You might have to reprogram your remote after installing new batteries. ) · Remote may not be compatible with your product. ⷠRemote may not be able to operate all features of your product or button names might be different than your product. Try to program the code again or try a different code. [. . . ]