User manual PHILIPS OS685

[. . . ] • Do not mix batteries (old and new or carbon and alkaline, etc. ). • Remove batteries when the unit is not used for a long time. Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like. [. . . ] • Erase a program. j AUDIO IN • Connect an external audio device. k FM antenna • Improve FM radio reception. 5 EN 3 Get started Caution •• Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. Always follow the instructions in this chapter in sequence. Connect power The CD Soundmachine can be powered by either AC power or batteries. Option 2: Battery power Caution •• Batteries contain chemical substances, so they should be disposed of properly. Option 1: AC power Warning supply voltage corresponds to the voltage printed on the back or the underside of the CD Soundmachine. When you disconnect the AC power, always pull the plug from the socket. Never pull the cord. Note •• Batteries are not supplied with the accessories. •• Risk of product damage!Make sure that the power 1 2 3 Open the battery compartment. Insert 6 batteries (type: R14/UM2/C CELL) with correct polarity (+/-) as indicated. Close the battery compartment. Connect the AC power cord to: • the AC~ MAINS socket on the back of the CD Soundmachine. • the wall outlet. Tip •• To save energy, turn off the CD Soundmachine after use. EN 6 Turn on Switch the POWER slide to ON position. »» The CD Soundmachine switches to the last selected source. »» The LED indicator turns on. 4 Play Play CD 1 2 3 OFF ON Rotate the source selector to the CD position. Insert a disc with the printed side facing upward, then close the disc tray. »» Play starts automatically. Note •• In CD or USB mode, if the CD Soundmachine is idle for 15 minutes, it switches to standby mode automatically. To exit the standby mode, press . Turn off Switch the POWER slide to OFF position. »» The LED indicator turns off. Play from USB devices Note •• Make sure that your USB device contains playable audio content. Adjust display brightness 1 2 Press and hold MODE for 3 seconds. Press ALB/PRESET -/+ repeatedly to adjust the display brightness. 1 2 Rotate the source selector to the USB position. »» Play starts automatically. If not, press . 7 EN Play from an external audio device You can also listen to an external audio device such as an MP3 player through this CD Soundmachine. 5 Play options Control play In CD or USB mode, you can control play through the following operations. / Select an audio file; Press and hold to fast-forward or fast-reverse the track during playback, then release to resume play. [. . . ] Do not use a solution containing alcohol, spirits, ammonia or abrasives. Clean discs • When a disc becomes dirty, clean it with a cleaning cloth. Wipe the disc from the centre out. USB playability information Compatible USB devices: • USB flash memory (USB 2. 0 or USB1. 1) • USB flash players (USB 2. 0 or USB1. 1) • memory cards (requires an additional card reader to work with this apparatus) Supported formats: • USB or memory file format FAT12, FAT16, FAT32 (sector size: 512 bytes) • MP3 bit rate (data rate): 32-320 Kbps and variable bit rate • WMA v9 or earlier • Directory nesting up to a maximum of 8 levels • Number of albums/ folders: maximum 99 • Number of tracks/titles: maximum 999 • ID3 tag v2. 0 or later 11 EN • Do not use solvents such as benzene, thinner, commercially available cleaners, or antistatic spray intended for analogue records. Clean the disc lens • After prolonged use, dirt or dust may accumulate at the disc lens. [. . . ]