User manual PHILIPS PERFECTCARE VIVA GC7035

[. . . ] After descaling is done, the steam function will be restored. This takes place regardless of the type of water used. Sound and light Calc-Clean reminder -- After 1 to 3 months of use, the light of the Calc-Clean button starts flashing and the appliance starts beeping to indicate that you have to perform the Calc-Clean process (Fig. -- You can continue steam ironing for 1 hour while the Calc-Clean light flashes and the appliance beeps. [. . . ] 8 Wipe the iron with a piece of cloth and put it back on the base station (Fig. 9 As the Calc-Clean container becomes hot during the Calc-Clean process, wait approx. 10 Carry the Calc-Clean container to the sink, empty it and store it for future use (Fig. 11 If necessary, you can repeat steps 1 to 10. Make sure that you empty the Calc-Clean container before you start the Calc-Clean process. Note: During the Calc-Clean process, clean water may come out of the soleplate if no scale has accumulated inside the iron. 8 ENGLISH Energy saving Eco mode By using the ECO mode (reduced amount of steam), you can save energy without compromising on the ironing result. 1 To activate the ECO mode, press the ECO button. €16) 2 To deactivate the ECO mode, press the ECO button again. For the best results on tough fabrics you can use the TURBO mode. 1 Press and hold the on/off button for 2 seconds until the light turns white. If the light in the Calc-Clean button still flashes and the appliance still beeps, perform the Calc-Clean process (see chapter ‘IMPORTANT - Cleaning and maintenance’). You have to perform the Calc-Clean process again (see chapter ‘IMPORTANT - Cleaning and maintenance’). Let the iron heat up until the ‘iron ready’ light lights up steadily. see chapter ‘IMPORTANT - Cleaning and maintenance’. After the Calc-Clean process, remaining water may drip out of the soleplate. The Calc-Clean process has not been completed. Dirty water and impurities come out of the soleplate. Impurities or chemicals present in the water have deposited in the steam vents and/or soleplate. You have accidentally started the Calc-Clean process (see chapter ‘IMPORTANT Cleaning and maintenance’). You have not pressed the Calc-Clean button for 2 seconds until the appliance started beeping. The surface to be ironed was uneven, for instance because you were ironing over a seam or a fold in the garment. [. . . ] When you release the steam trigger, remaining water is transformed into steam. When the iron is tilted upwards, remaining water is collected and converted into strong steam. € Solution Release the steam trigger 2 to 3 seconds before you place the iron back on the iron platform or ironing board. Problem Steam continues to come out after I release the steam trigger. [. . . ]