User manual PHILIPS PR3092/00

[. . . ] Always here to help you Register your product and get support at www. Com/welcome PR3092 User manual 23 English 6 Deutsch 26 Français 48 Italiano 69 PR3092 6 English Introduction Read this user manual carefully before you use the BlueTouch Pain Relief Patch and save it for future reference. This medical device is available without prescription. To achieve the optimal treatment success, you have to use the device according to the treatment schedule and the instructions in this user manual. [. . . ] For example, if you switch from mode 3 to mode 1 and the remaining treatment time in mode 3 was 5 minutes, the remaining treatment time in mode 1 is 10 minutes. In mode 1 the intensity is 50% of that in mode 3, which means that the treatment in mode 1 lasts twice as long as in mode 3. Treatment intensity When you select a treatment mode, you get audible and visible feedback. , , In mode 1 (low), two rows of LEDs light up. The BlueTouch Pain Relief Patch beeps three times. , , After you select a mode, the BlueTouch Pain Relief Patch switches on in power-save mode. In this mode all LEDs are on at their lowest intensity. , , When you place the BlueTouch Pain Relief Patch on the skin, treatment starts at the intensity of the mode selected (100% for mode 3, 75% for mode 2 and 50% for mode 1) and you get audible feedback. Preparing the BlueTouch Pain Relief Patch for use The preferred method for fastening the Pain Relief Patch to the body is by means of one of the BlueTouch Pain Relief straps. There is a special strap for treatment of the upper back and a special strap for treatment of the lower back. -- Lower back straps are available separately under type number PR3083, depending on your size. -- Upper back straps are available separately under type number PR3081, depending on your size. Note: Do not wear multiple layers of clothing or tight or thick clothing over the BlueTouch Pain Relief Patch to prevent the device from switching off before the treatment has been completed. If you wear too tight or thick clothing, the infrared sensor will measure a too high temperature and switch off the device. 18 English Positioning the lower back strap To place the BlueTouch Pain Relief Patch in the strap, follow the steps below. 1 Put the lower back strap and the BlueTouch Pain Relief Patch in front of you on a table. Slide the left side of the BlueTouch Pain Relief Patch behind the elastic edge of the opening in the strap. 2 Then slide the other end of the BlueTouch Pain Relief Patch behind the opposite elastic edge of the opening so that the whole patch is inside the lower back strap. Check to make sure that the LEDs are not covered by the material of the strap. If necessary, shift the BlueTouch Pain Relief Patch a little. 3 Remove clothing from the area to be treated. Note: Make sure the skin in the area to be treated is clean, entirely dry and free from creams, lotions and other cosmetics. [. . . ] Put the BlueTouch Pain Relief Patch back on your skin and continue your treatment. charge the BlueTouch Pain Relief Patch (see chapter ‘Charging’). Problem The BlueTouch Pain Relief Patch suddenly switches off during treatment. The BlueTouch Pain Relief Patch switched off and the charging light flashes red. [. . . ]