User manual PHILIPS PR3094/00

[. . . ] PR3094 PR3093 User manual 1 English 4 Deutsch 57 Italiano 118 Français 176 PR3094, PR3093 4 English Introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. Read this user manual carefully before you use the Wireless TENS (PR3093) or the Wireless TENS Pro (PR3094) and save it for future reference. The Wireless TENS (PR3093) and the Wireless TENS Pro (PR3094) are available without prescription. [. . . ] Note: For Burst TENS, you should feel the stimulation strongly, which generally gives a sharper sensation and can feel somewhat unpleasant. It is also advised to adjust the intensity to a level that produces visible muscle contractions in the stimulation area. If you find the contractions too uncomfortable, you can decrease the intensity, choose a different program or move the electrodes to a different place. , , The intensity level is shown in numbers above the intensity button. The intensity ranges from 0 mA to 60 mA. The intensity level is shown by the intensity level bar on the right side of the screen. The higher the bar, the higher the intensity. English 31 , , When the treatment starts, the treatment status indicator on the TENS units starts to flash yellow. , , The home screen of the remote control shows the program selected, the treatment time left and the intensity selected. , , If the intensity feels uncomfortable, press the - side of the intensity button to reduce the intensity constantly and slowly. Note: Since your body initially adapts to the intensity of the stimulation, you may have to adjust the intensity level after some time to ensure optimal stimulation. 2 To end the treatment before the set treatment time has elapsed or if you set the treatment duration to ‘continuous’, hold down the - side of the intensity button for 3 seconds to make the intensity drop to 0 mA. When the intensity level is 0 mA, no pulse is emitted by the TENS units. Note:You can also end the treatment by pressing the on/off button on the TENS units. In that case, treatment on both channels stops immediately. Starting and stopping a treatment (PR3094) To start a treatment, you first have to switch on the TENS units with the on/off button and then you press the + sides of the intensity buttons to increase the intensity. 1 Press the + side of the intensity buttons to set the intensity for the main and the extension channel separately and start the treatment. , , Hold down the + side of the intensity button on the left side of the remote control to increase the intensity of the main channel. This starts the pulse between the first two electrodes. 32 English , , The intensity level is shown in numbers above the left intensity button. The intensity level is also shown by the intensity level bar on the left side of the screen. , , Hold down the + side of the intensity button on the right side of the remote control to increase the intensity of the extension channel. [. . . ] -- This symbol means ‘Manufactured by’ and appears next to the address of the legal manufacturer. 0344 is the number of the notified body. -- This symbol means: Do not throw away with the normal household waste. For further instructions, see chapter ‘Recycling’. [. . . ]