User manual PHILIPS QC 5135

[. . . ] Make sure that the arms of the comb have been properly slid into the grooves on both sides. 3 Press the length setting selector (1) and then move the hair clipping comb up or down (2) to set the desired length setting (Fig. Length settings With the hair clipping comb attached, the appliance can cut hair to 10 different lengths: Hair lengths in mm Hair lengths in inches 3 5 7 9 11 13 15 17 19 21 1/8 3/16 9/32 3/8 7/16 1/2 5/8 21/32 3/4 7/8 Clipping without hair clipping comb You can use the appliance without hair clipping comb to clip your hair very close to the skin, to a length of 1mm (1/32 in) to contour the neckline and the area around the ears. 1 To remove the hair clipping comb, press the length setting selector (1), move the comb upwards and then pull it off the appliance (2). [. . . ] Make sure that the flat part of the hair clipping comb is fully in contact with the scalp to obtain an even clipping result. To achieve a good result with curly, sparse or long hair, you can use a styling comb to guide the hair towards the appliance. Regularly remove cut hair from the hair clipping comb. If a lot of hair has accumulated in the comb, remove it from the appliance and blow and/or shake the hair out of it. Compliance with standards This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled properly and according to the instructions in this user manual, the appliance is safe to use based on scientific evidence available today. Charging Do not charge the appliance for more than 24 hours. 5 Place the beard trimming comb on the face and move the appliance through the hair slowly (Fig. Tips When you trim your beard for the first time, start at a length setting that is higher than the length of your beard hairs and reduce the length setting gradually. To trim in the most effective way, move the appliance against the direction of hair growth. Make overlapping passes over the chin to ensure that the appliance catches all the hairs that need to be cut. Make sure that the flat part of the beard trimming comb is fully in contact with the face to obtain an even trimming result. Regularly remove cut hair from the beard trimming comb. If a lot of hair has accumulated in the comb, remove it from the appliance and blow and/or shake the hair out of it. Creating a stubble beard To create a stubble beard, trim with the beard trimming comb set to 1. Note:The CHARGE light does not indicate when the appliance is fully charged. Optimising the lifetime of the rechargeable batteries Discharge the rechargeable batteries completely twice a year by letting the motor run until it stops. Clipping without beard trimming comb To trim your facial hair even shorter than 1. 5mm (1/16in), use the appliance without beard trimming comb. this results in a stubble beard of 1mm (1/32 in). [. . . ] 2 Remove the hair clipping or beard trimming comb and the cutting unit. 3 Remove the 2 screws at the back of the appliance with a screwdriver (Fig. 4 Pull the back panel off the appliance (Fig. 5 Remove the 6 screws on the inside of the appliance with a screwdriver (Fig. [. . . ]