User manual PHILIPS QG3340/16

[. . . ] νικα 44 Suomi 58 Français 70 Nederlands 83 Español 96 Italiano 109 Norsk 122 Português 135 Svenska 148 Türkçe 161 QG3340 4 English Introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. €1) 1 Beard trimmer 2 Handle 3 On/off slide 4 Pouch 5 Cleaning brush 6 Nose/ear trimmer 7 MIni-foil shaver 8 Full metal precision trimmer 9 Stubble comb 10 Beard comb 11 Guiding grooves 12 Setting indicator 13 Adapter Important Read this user manual carefully before you use the appliance and save it for future reference. Warning -- Check if the voltage indicated on the adapter corresponds to the local mains voltage before you connect the appliance. [. . . ] Turn the nose/ear trimmer clockwise to fix it (2). 3 Switch on the appliance and insert the tip of the trimmer into one of your nostrils. 4 Slowly move the tip in and out while turning it round at the same time to remove unwanted hair. To reduce the tickling effect, make sure that you press the side of the tip firmly against the skin. 10 English Trimming ear hair 1 Attach the nose/ear trimmer onto the handle. 3 Switch on the appliance and move the tip softly round the ear to remove hairs that stick out beyond the rim of the ear. 4 Carefully insert the tip into the outer ear channel. 5cm into the ear channel as this could damage the eardrum. Cleaning Never use compressed air, scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the appliance. The appliance is waterproof therefore the handle, combs and attachments are easily cleaned under the tap. 1 Make sure the appliance is switched off and disconnected from the mains. 2 Remove any comb and/or attachment from the appliance. English 11 3 Blow and/or shake out any hair that has accumulated in the attachments and/or combs or use the cleaning brush. 4 Clean the attachments and the combs under a lukewarm tap and/or with the cleaning brush. 5 Clean the handle under a lukewarm tap and/or with the cleaning brush. Cleaning the mini-foil shaver 1 After each use, pull the top part of the mini-foil shaver off the bottom part. If the shaving foil is damaged, do not use the minifoil shaver anymore. Do not clean the shaving foil with the cleaning brush, as this may cause damage. 2 Blow and/or shake out any hair that has accumulated inside the mini-foil shaver. 3 Clean the top part of the mini-foil shaver under a lukewarm. Storage Store the handle, combs, attachments and adapter in the storage pouch supplied to prevent damage. 12 English Ordering accessories To purchase accessories for this appliance, please visit our online shop at www. [. . . ] Possible cause You do not attach the beard comb correctly. Solution Slide the beard comb into the guiding grooves on both sides of the handle until you hear a click. Clean the appliance and the guiding grooves thoroughly. Go to your Philips dealer or contact a Philips service centre to purchase a new comb. [. . . ]