User manual PHILIPS RQ1187

[. . . ] Always here to help you Register your product and get support at www. Com/welcome RQ1145 RQ1141 User manual 1 English 6 Français 28 Indonesia 51 한국어 74 Bahasa Melayu 96 Português 119 Español 142 繁體中文 165 简体中文 186 226 246 RQ119x, RQ118x, RQ117x, RQ116x, RQ115x, RQ114x, RQ113x 6 English Introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. Please read this user manual, as it contains information about the features of this shaver as well as some tips to make shaving easier and more enjoyable. [. . . ] The hair length settings on the Beard Styler attachment correspond to the remaining hair length after cutting and range from 1 to 5mm. English 15 1 Slide the comb straight into the guiding grooves on both sides of the Beard Styler attachment (‘click’). 2 Press the length selector (1) and then push it to the left or right (2) to select the desired hair length setting. 3 Press the on/off button on the shaver to switch it on. 4 You can now start styling your beard. 18 English Cleaning the shaving unit in the Jet Clean System (specific types only) The Jet Clean System has an automatic cleaning program. When you press the on/off button, the Jet Clean System starts cleaning in this automatic cleaning program. Preparing the Jet Clean System for use Fill the cleaning chamber before first use. 1 Put the small plug in the Jet Clean System. , , The holder automatically moves to the highest position. 3 Simultaneously press the release buttons on both sides of the cleaning chamber (1). Then lift the Jet Clean System off the cleaning chamber (2). , , The cleaning chamber remains behind. 4 Unscrew the cap from the bottle with HQ200 cleaning fluid. € 5 Fill the cleaning chamber with HQ200 cleaning fluid to a level between the two lines. 6 Place the Jet Clean System back onto the cleaning chamber. Make sure the release buttons click back into place. Using the Jet Clean System Note: If you use the shaver with shaving foam or shaving gel, we advise you to rinse it under the hot tap before you clean it in the Jet Clean System. This guarantees an optimal lifetime for the cleaning fluid. 1 Hold the shaver upside down above the holder with the back of the shaver pointing towards the holder. English 19 2 Place the shaver body in the holder behind the two clips (1) and press it down until it locks into place (2). , , The display shows that the shaver is charging (see chapter ‘The display’). [. . . ] The shaver does not work when I press the on/off button. The shaving head holder is soiled or damaged to such an extent that the motor cannot run. The temperature of the shaver is too high. Specific types only: The shaver is not entirely clean after I clean it in the Jet Clean System. [. . . ]