User manual PHILIPS RQ 1290

[. . . ] Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. Please read this user manual, as it contains information about the features of this shaver as well as some tips to make shaving easier and more enjoyable. 1) A 1 2 3 4 5 6 7 B C 1 2 3 4 5 6 D E F G Shaver (RQ1290/RQ1280/RQ1260/RQ1250) Trimmer Trimmer on/off slide Shaving unit Protection cap Shaver Shaver on/off button Display Charger Jet Clean System (RQ1008/RQ1007) (specific types only) Shaver holder 'Cleaning chamber empty' symbol Cleaning symbol Drying symbol Jet Clean System on/off button (RQ1008 only: and up/down button for program selection) Cleaning chamber release button Cleaning brush Cleaning fluid Pouch Adapter important Read this user manual carefully before you use the appliance and save it for future reference. [. . . ] Note: Do not turn the shaving unit while you pull it off the shaver. 2 Press the on/off button once to switch on the shaver. , The display lights up for a few seconds. 6 Press the on/off button once to switch off the shaver. , The display lights up for a few seconds and shows the remaining battery capacity. Cleaning and maintenance Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the shaver and the Jet Clean System (specific types only). The best and most hygienic way to clean the shaver is in the Jet Clean System (specific types only). You can also rinse the shaver under the tap or clean it with the cleaning brush supplied. Always check if the water is not too hot, to prevent your hands from getting burnt. Clean the shaver after every shave for optimal shaving performance. You can clean the outside of the shaver with a damp cloth. regular cleaning guarantees better shaving performance. Cleaning the shaving unit Be careful with hot water. Always check if the water is not too hot, to prevent your hands from getting burnt. 1 Rinse the shaving unit under a hot tap for some time (Fig. 2 Pull open the three shaving heads one by one (Fig. 3 Rinse all three shaving heads and all three hair chambers under a hot tap for 30 seconds. 28) Note:You can also brush the shaving heads and hair chambers with the cleaning brush supplied. Always check if the water is not too hot, to prevent your hands from getting burnt. 4 Carefully shake off excess water and leave the shaving heads open to let the shaving unit dry completely. Never dry the shaving unit with a towel or tissue, as this may damage the shaving heads. Cleaning the shaving unit in the Jet clean system (specific types only) The Jet Clean system comes in two types: - Type RQ1008 has three cleaning programs: the eco program, the auto program and the intensive program. [. . . ] Refill the cleaning chamber with cleaning fluid to a level between the two lines (see chapter `Cleaning and maintenance'). Put the small plug in the Jet Clean System and put the adapter in the wall socket. Press the shaver tightly into the holder to lock it into place. Make sure you press the shaver until it locks into place. [. . . ]