User manual PHILIPS S231C4AFD/00

[. . . ] We have done our utmost to make the packaging easil separable into mono materials. Please nd out about the local regulations on how to dispose of our old monitor and packing from our sales representative. Un a ut h Philips and the Philips’ Shield Emblem are registered trademarks of Koninklijke Philips N. And are used under license from Koninklijke Philips N. [. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequenc energ and, if not installed and used in accordance with the instructions, ma cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined b turning the equipment off and on, the user is encouraged to tr to correct the interference b one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an e perienced radio/TV technician for help. Changes or modi cations not e pressl approved b the part responsible for compliance could void the user's authorit to operate the equipment. Use onl RF shielded cable that was supplied with the monitor when connecting this monitor to a computer device. To prevent damage which ma result in re or shock hazard, do not e pose this appliance to rain or e cessive moisture. tHIS CLASS B IGITAL APPARATUS MEETS ALL RE UIREMENTS OF THE CANA IAN INTERFERENCE-CAUSING EQUIPMENT REGULATIONS. Eclaration of Conformit for Products Marked with FCC Logo, This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device ma not cause harmful interference, and (2) this device must accept an interference received, including interference that ma cause undesired operation. CAN ICES-3(B)/NMB-3(B) The equipment should draw power from a socket with an attached protection circuit (a three-prong socket). All equipment that works together (computer, monitor, printer, and so on) should have the same power suppl source. The phasing conductor of the room's electrical installation should have a reserve short-circuit protection device in the form of a fuse with a nominal value no larger than 16 amperes (A). To completel switch off the equipment, the power suppl cable must be removed from the power suppl socket, which should be located near the equipment and easil accessible. A protection mark B con rms that the equipment is in compliance with the protection usage requirements of standards PN-93/T-42107 and PN-89/E-06251. All products produced and sold for China market have to meet China RoHS request. RoHS (Pb) O (Hg) O O (Cd) O O O O O (Cr6 ) O O O O O (PBB) O O O O O (PB E) O O O O O The European Energ Label informs ou on the energ ef cienc class of this product. The greener the energ ef cienc class of this product is the lower the energ it consumes. On the label, ou can nd the energ ef cienc class, the average power consumption of this product in use and the average energ consumption for 1 ear. [. . . ] Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an e perienced radio/ TV technician for help. FCC Caution: An changes or modi cations not e pressl approved b the part responsible for compliance could void the user’s authorit to operate this equipment. [. . . ]