User manual PHILIPS S5400/41

[. . . ] Series S5000 1 1 2 19 18 20 21 3 4 22 5 6 7 8 9 10 11 17 16 15 14 13 12 26 27 23 25 24 ENGLISH 4 DANSK 36 DEUTSCH 69 ΕΛΛΗΝΙΚΑ 105 ESPAÑOL 143 SUOMI 179 FRANÇAIS 211 ITALIANO 245 NEDERLANDS 279 NORSK 313 PORTUGUÊS 344 SVENSKA 379 TÜRKÇE 411 S5000 series 4 ENGLISH Introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. The box shows the accessories that have been supplied with your appliance. Important safety information Read this important information carefully before you use the appliance and its accessories and save it for future reference. [. . . ] ENGLISH 21 1 Press the button on the side of the SmartClean system and lift the top part of the SmartClean system. 2 1 2 Take the empty cleaning cartridge from the SmartClean system and pour any remaining cleaning fluid out of the cleaning cartridge. You can simply pour the cleaning fluid down the sink. 3 Throw away the empty cleaning cartridge. 4 Unpack the new cleaning cartridge and pull the seal off the cartridge. 5 Place the new cleaning cartridge in the SmartClean system. 6 Push the top part of the SmartClean system back down (‘click’). Cleaning the shaver under the tap Clean the shaver after every shave for optimal shaving performance. Always check if the water is not too hot, to prevent your hands from getting burnt. Never dry the shaving unit with a towel or tissue, as this may damage the shaving heads. 22 ENGLISH 1 Rinse the shaving unit under a warm tap for some time. 2 Press the release button and open the shaving unit. 3 Rinse the shaving head holder under a warm tap for 30 seconds. 4 Carefully shake off excess water and let the shaving head holder dry. 5 Close the shaving head holder (‘click’). thorough cleaning method Make sure the appliance is switched off. 1 Press the release button and open the shaving unit. 2 Pull the shaving head holder off the bottom part of the shaving unit. ENGLISH 23 2 1 3 Turn the retaining rings anticlockwise and remove them. 4 Remove the shaving heads from the shaving head holder. Each shaving head consists of a cutter and guard. Note: Do not clean more than one cutter and guard at a time, since they are all matching sets. [. . . ] Switch on the appliance and rinse the cutting element once more to remove any remaining hairs. If rinsing the nose trimmer under the tap does not unblock the cutting element, then immerse it in a glass with warm water for a few minutes. Then switch on the appliance and rinse it under the tap. 36 DANSK Introduktion Tillykke med dit køb og velkommen til Philips! [. . . ]