User manual PHILIPS SBCRU252-00H

[. . . ] The example below (TV) instructs you how to do this. You can repeat the same steps for other appliances (VCR/DVD players/recorders) which you want to operate using the RU252. Example of TV: 1 Turn your TV on manually or use the original remote control. 2 Press the RU252's TV key to select TV. 3 ­ Check whether all the keys are working. [. . . ] The green indicator light will now flash twice. If the light flashes once for an extended period, the code has not been entered properly or the wrong code has been entered. Point the RU252 at the TV and check that it responds as it should. If the TV responds to all of the key commands, the RU252 is ready for use. If the device does not respond at all, or not to all of the key commands, start again from step 2 and try the next code from the list. · RU252. qxd 04-06-2004 16:55 Pagina 6 Instructions for use Automatically setting the remote control If you cannot find the right code for your brand device, the remote control can automatically search for the right code. Example of TV: 1 Make sure the TV is switched on and select a channel using the original remote control or the keys on the TV (for example channel 1). The RU252 emits the `switch off TV' signal for all models of TV that are stored in the memory. · If the device is a DVD-player or video recorder, insert a disk or tape and start playback. 2 Then keep keys 1 and 3 on the RU252 pressed simultaneously for three seconds, until the green indicator light remains lit. English 6 3 Press the Standby key of the RU252 briefly. ­ The RU252 now starts emitting all known `TV off ' signals, one by one. Each time a code is sent, the green indicator light flashes. 4 ­ When your TV switches off (stand-by), you press the Standby key of the RU252 twice within 1 second, to confirm. The RU252 has now found a code that works on your TV. 5 · Check if you can operate all functions on your TV with the RU252. If this is not the case, you can redo the automatic setting. The RU252 will then search for a code that perhaps works better. After the RU252 has run through all the known codes, the search will stop automatically and the green light will stop flashing. Automatic programming of a TV takes a maximum of 8 minutes. For VCR/DVD this time is 4 minutes. ­ ­ RU252. qxd 04-06-2004 16:55 Pagina 7 Instructions for use English 7 3. Keys and functions The illustration on page 3 gives an overview of all keys and their functions. - lights up green when an IR signal is being sent. [. . . ] - blue teletext key - wind (VCR/DVD) 2 . selects between one- and two-figure channel numbers. switches between external inputs of your equipment. [. . . ]