User manual PHILIPS SBCRU430

[. . . ] Most of the keys work just like on your original remote control. Of course, if your TV or VCR does not offer a specific function, pressing that key will have no effect. Remember to replace the batteries at least once a year. Don't leave the batteries out for longer than one hour, otherwise you will need to set the remote up again. [. . . ] philips' patented Handsfree autosearch tests all the codes one after another and finds the right one for you!The search time averages about 90 seconds. You will know when the correct code has been found because the equipment will switch off or the VCR will stop playback. 1 Press and hold 1 and 3 at the same time until the green LED lights up. Each time the green LED blinks, another code is sent. When the right code is found, the equipment switches off (the VCR will stop playing). If you missed the correct code because the search went too far, switch the equipment back on, then press P (down) to send the previous code again. Press P (down) repeatedly until the equipment switches off again. 4 Once you've found the correct code, press The green LED blinks twice. Now, switch the equipment manually on again, then press a few keys on the remote to check that the equipment responds correctly. In the rare instance that it doesn't, try again from step 1 to find a better code. To save time if you ever need to setup again, make a note of the correct code inside the battery case and in the back of this booklet. In case you have forgotten to note the code you can still 'read out' the code from the remote. Here's how: 1 Make sure you've selected the right mode (with ). Then press and release 1 and 6 at the same time; the green LED lights up. 3 Press 1 and count the number of times the green LED blinks. This is the first digit of the 3-digit code. ) Press 2 and count the number of blinks for the second digit. Press 3 and count the number of blinks for the third digit. ADVANCED TIPS AND TRICKS TO CHANGE SAT MODE TO CONTROL A SECOND TV The SAT mode on this remote is used to control additional equipment. It is factory preset to control a satellite receiver, but you can change it to control a second TV, for example. Before you start, press to select SAT, and make sure the second TV is switched on. [. . . ] Look for below unique full range of universal remote controls from Philips at a retailer near you. RU RU RU RU 110 410 422 440 : : : : Universal easy TV zapper 1 in 1 Universal TV Remote with digits and TXT 2 in 1 Universal Remote Control for TV and VCR 4 in 1 Universal Remote Control for TV, VCR, SAT/Cable and AUX for audio 4 in 1 Universal Remote Control for TV, VCR, SAT/Cable and AUX for second device 6 in 1 Universal Remote Control- Pre-programmed and Learnable Another very nice product from Philips is the Philips SBC LI510 Remote Control Extender Set, the wireless extension of your infra-red (IR) remote control!This system allows you to operate every IR driven equipment (i. Sat-receivers, VCRs or Hi-Fi-sets) from anywhere in or around the house. [. . . ]