Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual PHILIPS SBCSC763. We hope that this PHILIPS SBCSC763 user guide will be useful to you.
Lastmanuals help download the user guide PHILIPS SBCSC763.
Detailed instructions for use are in the User's Guide.
[. . . ] Check the power consumption of the selected appliance before plugging it into the Power switch. The Power switch can control appliances with a maximum power rating of 1000 Watts! If the selected appliance has its own ON/OFF switch, make sure they are switched on. [. . . ] The Power switch operates with button 1 as its default setting. if the right side (+) of the button is pressed , the selected appliance switches on. If the left side (-) of the button is pressed, the selected appliance switches off again. Insert the batteries in the unit, checking carefully that the battery polarities (+ and -) match those inside the compartment. Notes: Remove the batteries when the remote control is not going to be used for a long period of time. Batteries in the remote control should be replaced once a year. INSTALLATION Your appliance must be connected to the Power switch before you can control it with the remote control (fig. CHANGING THE HOUSE CODE The house code is meant to prevent interference with the Power Control System of your neighbour. The Power Control System will only respond to signals with the correct house code. Set the house code of the remote control by turning the house code selection wheel (AP) with a screwdriver. Set the house code of the Power switch by turning the house code selection wheel at the rear of the switch (A-P) with a screwdriver. CHANGING UNIT CODE A unit code should be set on the Power switch. The selected unit code corresponds to the button which has to be pressed on the remote control. Set the unit code of the Power switch by turning the unit code selection wheel at the rear of the plug (1-16) with a screwdriver. [. . . ] Set the unit code of the Power switch by turning the unit code selection wheel at the rear of the plug (1-16) with a screwdriver. It is possible to activate more Power switches at the same time by selecting the same unit code. Note: Although the unit code on the Power switch can be set from 1 to 16, the remote control can only operate Power switches with unit code set from 1 to 8. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE PHILIPS SBCSC763
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual PHILIPS SBCSC763 will begin.
