User manual PHILIPS SBT30BLU

[. . . ] 8) 2 Comb the hair ends over the ears before you start to contour the hairline. 4 Tilt the appliance in such a way that only one edge of the cutting element touches the hair ends. the hairline has to be close to the ear. 6 To contour the neckline and the sideburns, turn the appliance and make downward strokes (Fig. [. . . ] Do not use the appliance in the bath or in the shower. Use, charge and store the appliance at a temperature between 15°C and 35°C. only use the adapter supplied to charge the appliance. If the adapter is damaged, always have it replaced with one of the original type in order to avoid a hazard. Do not use the appliance if the cutting element, the hair clipping comb or the beard trimming comb is damaged or broken, as this may cause injury. This appliance is only intended for clipping human scalp hair and facial hair. 5 Place the hair clipping comb on the scalp and move the appliance through the hair slowly. tips Start clipping at the highest length setting of the hair clipping comb and reduce the length setting gradually. Write down the length settings you have used to create a certain hairstyle as a reminder for future clipping sessions. To clip in the most effective way, move the appliance against the direction of hair growth. Since hair grows in different directions, you need to move the appliance in different directions as well (upward, downward or across) (Fig. 14) 2 Place the trimmer on the face and move the appliance through the hair slowly (Fig. Cleaning Never use compressed air, scouring pads, abrasive cleaning agents or aggressive liquids such as alcohol, petrol or acetone to clean the appliance. Only clean the appliance and the adapter with the cleaning brush supplied. Do not use any sharp objects to clean the appliance. 1 Make sure the appliance is switched off and disconnected from the mains. 2 To remove the comb, press the length setting selector (1), move the comb upwards and then pull it off the appliance (2). 8) 3 Push the middle part of the cutting unit upwards with your thumb until it opens (Fig. 5 Clean the inside of the appliance with the cleaning brush supplied (Fig. 6 Clean the hair clipping comb and the beard trimming comb with the cleaning brush supplied. Note:The appliance does not need any lubrication. Replacement The cutting unit, the adapter and the hair clipping comb are replaceable. [. . . ] The staff of this centre will remove the batteries for you and will dispose of them in an environmentally safe way (Fig. Make sure the batteries are completely empty when you remove them. Do not connect the appliance to the mains again after you have removed the rechargeable batteries. 1 Disconnect the appliance from the mains and let the appliance run until the motor stops. [. . . ]