User manual PHILIPS SCD501/00

[. . . ] ς ES Manual del usuario 3 11 20 30 FR Mode d’emploi IT Manuale utente PT Manual do utilizador 70 38 46 54 IL Congratulations on your purchase and welcome to Philips AVENT!To benefit fully from the support that Philips AVENT offers, register your product at www. 1 Danger •• Never immerse any part of the baby monitor in water or any other liquid. Do not place where water or any other liquid can drip or splash onto it. [. . . ] Then push the lid home until it locks into place with a click. €¢â€¢ To prevent a high-pitched sound from one or both units, make sure the parent unit is at least 1. 1 Positioning the baby monitor B Warning: Keep the baby unit out of the reach of the baby. Never place the baby unit inside the baby’s bed or playpen. €¢â€¢ Because the cord of the baby unit presents a potential strangulation hazard, make sure that the baby unit and its cord are at least 1 metre/3. 2 Linking parent unit and baby unit 1 Press and hold the 3 button on the baby unit for 3 seconds until the power-on light lights up. 2 Press and hold the 3 button on the parent unit for 3 seconds until the ‘link’ light starts flashing red. 6 Dry materials •• If no connection is established, the ‘link’ light continues to flash red and the parent unit beeps. 1 Smart Eco mode What to do if no link is established •• If the parent unit is out of range, place it closer to the baby unit. €¢â€¢ If the baby unit or parent unit is too close to another DECT appliance (e. A cordless phone), switch off this appliance or move the unit away from this appliance. €¢â€¢ If the baby unit is switched off, switch it on. This mode is always active and automatically reduces the DECT signal from the baby unit to the parent unit to save energy and reduce radio transmission. 1 Nightlight The nightlight produces a soft glow that comforts your baby. 1 Press the nightlight button on top of the baby unit to switch the nightlight on or off. €¢â€¢ The operating range is up to 300 metres/985 feet outdoors and up to 50 metres/150 feet indoors. €¢â€¢ The operating range of the baby monitor varies depending on the surroundings and factors that cause signal attenuation. Wet and moist materials cause so much signal attenuation that the range loss is up to 100%. 7 E N GL IS H •• When the parent unit and baby unit are linked, the ‘link’ light turns solid green. For signal attenuation from dry materials, see table below. 1 Battery light 1 2 The battery light is off when the parent unit is connected to the mains or the batteries contain enough energy. 2 When the batteries are low, the battery light flashes red and the parent unit beeps. [. . . ] €¢â€¢ If the parent unit beeps while the ‘link’ light flashes red continuously, the connection with the baby unit is lost. Move the parent unit closer to the baby unit or switch on the baby unit if it was off. Why does the appliance produce a high-pitched noise?€¢â€¢ The units may be too close to each other. [. . . ]