User manual PHILIPS SCD600/10

[. . . ] Register your product and get support at www. Com/welcome SCD600 1 1 2 3 4 5 6 7 8 16 15 14 13 12 11 10 22 21 20 9 17 18 19 1 2 8 9 10 3 11 7 6 12 13 4 5 14 English 6 español 16 Português do Brasil 27 SCD600 6 English Introduction Congratulations on your purchase and welcome to Philips AVENT!To fully benefit from the support that Philips AVENT offers, register your product at www. The Philips AVENT video monitor provides you with round-the-clock support and it allows you to see your baby day and night from anywhere in the house. [. . . ] -- As long as the baby unit does not detect a sound, all sound level lights on the parent unit are out. -- When the baby unit picks up a sound, one or more sound level lights on the parent unit go on. The number of lights that go on is related to the loudness of the sound picked up by the baby unit. The sound level lights also go on when the parent unit is set to a low volume or when the automatic screen activation mode is activated (see section ‘Automatic screen activation’ below) (Fig. English 11 Automatic screen activation The parent unit continuously monitors the sound level in your baby´s room. When the automatic screen activation mode is activated, the video display only switches on when the baby unit picks up a sound. As long as no sound is detected, the video display is off to save power. 1 To activate the automatic screen activation mode,  press the automatic screen activation button on the parent unit. €24) , , The automatic screen activation light on the parent unit goes on (Fig. , , When the baby unit detects a sound, the video display on the parent unit automatically goes on to show the baby. When no sound is detected for 30 seconds, the video display goes out again. do not use cleaning spray or liquid cleaners. 1 Switch off the baby unit and the parent unit and unplug them if they are connected to the mains. 2 Clean the parent unit and the baby unit with a damp cloth. Note: Fingerprints or dirt on the lens of the baby unit may affect the camera’s performance. Avoid touching the lens with your fingers. Make sure the baby unit and parent unit are dry before you connect them to the mains again. Storage When you are not going to use the baby monitor for some time, remove the non-rechargeable batteries from the baby unit and the rechargeable battery from the parent unit. Store the parent unit, the baby unit and the adapters in a cool and dry place. Replacement The following items are replaceable: -- Magnetic stand for baby unit -- Adapters. -- Input: 100-240V ~ 50/60Hz 250mA Output: 6Vdc 800mA -- Li-ion rechargeable battery -- Battery compartment lid Note: Only replace the stand, adapters, rechargeable battery and battery compartment lid with ones of the original type. Accessories You can order a new adapter from your Philips dealer or a Philips service centre under type number OH-1048A0600800U2-BZ. [. . . ] Interference may also occur if there are too many walls or ceilings between the parent unit and the baby unit or when other 2. Put the parent unit in a different place, closer to the baby unit, or switch off other wireless devices. The rechargeable battery of the parent unit may need to be charged. Why isn’t there any image on the video display when the power-on light is on? [. . . ]