User manual PHILIPS SENSEO CSA220/61

[. . . ] English Important safety information Read this user manual carefully before you use the machine and save it for future reference. danger - Never immerse the machine in water or any other liquid. warning - Check if the voltage indicated on the bottom of the machine corresponds to the local mains voltage before you connect the machine. - Connect the machine to an earthed wall socket. [. . . ] Check if the sealing ring of the lid is stuck under the edge of the distribution disk. If it is, pull it out from under the distribution disk carefully. Check if you have set the Intensity Select slide to the preferred volume setting. The sieve in the center of the pod holder is clogged. Descale the machine according to the instructions (see 'Descaling the Senseo'). Tip: before brewing coffee, preheat the cup by rinsing it with hot water or brew a coffee without coffee pod. Pull up the lever and wait 24 hours before you open the lid. To prevent this from happening, make sure that the sieve in the pod holder is clean and not clogged. Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. After the flushing cycle, the machine is ready for brewing coffee. 1 Fill up the water reservoir with fresh cold tap water. 2 Place the water reservoir back onto the machine. 4 Make sure that a pod holder, without pod(s), is in place. 6 Put the plug in an earthed wall socket. 7 To start flushing, press the 1-cup button and the 2-cup button simultaneously. 8 During the flushing cycle, cold water comes out of the coffee spout. 9 When the flushing cycle is finished, the machine switches off. Caution: If you do not flush the machine before first use, your first coffee cup may overflow with cold water. brewing coffee 1 Fill up the water reservoir with fresh cold tap water. 3 To brew one cup of Senseo coffee, place the 1-cup pod holder with one Coffee pod in the machine. To brew two cups, place the 2-cup pod holder with two coffee pods in the machine. [. . . ] 11 Press simultaneously the 1-cup button and 2-cup button to start flushing the remainder of the mixture through the machine. 12 The remainder of the descaling mixture comes out of the machine at intervals. The 1-cup button and 2-cup button flash simultaneously during this process. 13 As soon as the water tank is empty, the 1-cup button and 2-cup button flash quickly again. [. . . ]