User manual PHILIPS SENSEO TWIST HD7871

[. . . ] To ensure a smooth and full coffee taste, you should keep the following things in mind: Clean cold water Use clean cold water every day. If you have not used the coffee machine for one day, you have to flush it with clean cold water before you use it again. To flush the machine, fill the water reservoir with clean cold water, place a bowl or 2 cups under the coffee spout and press the 2-cup button a few times to brew hot water until the water reservoir is empty. Fresh coffee pods Use the SENSEO® coffee pods that have been specially developed by Douwe Egberts for your SENSEO® coffee machine for a full, round taste. [. . . ] This means that this machine complies with European Directive 2005/32/EC, which sets the ecological design requirements for energy-using products. Ordering accessories To buy accessories or spare parts, visit www. You can also contact the Philips Consumer Care Centre in your country (see the worldwide guarantee leaflet for contact details). Recycling -- This symbol means that this product shall not be disposed of with normal household waste (2012/19/EU) (Fig. -- Follow your country’s rules for the separate collection of electrical and electronic products. Correct disposal helps prevent negative consequences for the environment and human health. Frost-free storage If you already used the coffee machine and have therefore already flushed it with water, you may only use and store it in a frost-free place to prevent it from becoming damaged. Guarantee and support If you need information or support, please visit www. Com/ support or read the separate worldwide guarantee leaflet. The purchase of the Philips SENSEO® coffee machine does not exhaust any of the rights of D. E Masterblenders 1753 or Philips under any of their patents nor does it confer upon the purchaser a licence under these patents. I accidentally activate the touch panel when I clean it. Always unplug the machine before you clean it. The CALC light does not go out after descaling. My cup overflowed when I used the machine for the first time. water continued The machine was performing the flushing cycle. You have to place a bowl of 2 litres under the spout. To flow from the spout when I used the machine for the first time. The on/ off button continues to flash rapidly. Make sure that there is enough water in the water reservoir and that the water reservoir is placed properly. Make sure that you do not overfill the water reservoir. Check that you place the water reservoir on the appliance correctly. [. . . ] 2 minutes), the machine is ready for brewing SENSEO® coffee. Direct start You can select the coffee strength and the number of cups while the machine is heating up. As soon as the machine has heated up, it immediately brews the cup or cups at the desired strength. Brewing You can stop the brewing cycle at any time by pressing the same button (1-cup button or 2-cup button) that you pressed to start brewing coffee. [. . . ]