User manual PHILIPS SENSEO VIVA

[. . . ] -- Connect the machine to an earthed wall socket. -- If the mains cord is damaged, you must have it replaced by Philips, a service center authorized by Philips or similarly qualified persons in order to avoid a hazard. -- Do not use the machine if the plug, the mains cord or the machine itself is damaged. -- This machine can be used by children aged from 8 years and above and by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the machine in a safe way and if they understand the hazards involved. [. . . ] If you are unable to solve the problem with the information below, visit www. Com/support for a list of frequently asked questions or contact the Consumer Care Center in your country. You have pressed the 1-cup button and the 2-cup button at the same time. If you did not intend to start the descaling cycle, simply press the on/off button to switch off the machine. If you did intend to start the descaling cycle, do not interrupt this cycle but let the machine operate until the water reservoir is empty. The CALC light lights up continuously after descaling. The descaling procedure has not been completed. Do not switch off the machine during descaling. Water continued to flow from the spout when I used the machine for the first time. The machine was performing the flushing cycle. The light ring around the on/off button continues to flash rapidly. Make sure that there is enough water in the water reservoir and that the water reservoir is placed properly. There is not enough water in the water reservoir (i. Above the MIN level if you want to brew 1 cup). Check if the float in the water reservoir is stuck. Empty the water reservoir and shake it a few times to release the float. Clean the water reservoir with hot water and some washing-up liquid or in the dishwasher. Pull up the lever and wait 24 hours before you open the lid. Always make sure the pod holders are clean and the sieve is not clogged to prevent a vacuum. For Intensity Select models only: You may have Less coffee than the machine brews a short strong coffee. If the sieve is clogged, use a washing-up brush to unclog the sieve. If you cannot clean it properly with the washing-up brush, put the pod holder in the machine and descale the machine (see 'CALC'). [. . . ] The descaling procedure consists of two descaling cycles and two flushing cycles. For each descaling cycle, you have to pour half a bottle of descaling liquid into the water reservoir and fill it up with fresh water. Use the 1-cup pod holder with a used pod or the thin descaling filter during the first descaling cycle and use the 2-cup pod holder with a used pod or the thick descaling filter during the second descaling cycle. Do not interrupt the descaling cycles and do not switch off the machine before you have performed the two flushing cycles. [. . . ]