User manual PHILIPS SRU5150

[. . . ] Congratulations on your purchase of the Philips SRU 5150 universal remote control. the SRU 5150 is capable of operating up to 5 different devices. During setup you can define yourself exactly which devices will be operated (see table below). You can find information on how to prepare the SRU 5150 for use in chapter 2 `Setting up the remote control'. [. . . ] The display shows ` ' together with e. If the display shows `ERROR` or `MEM FULL', start again from step 1. Use 3 and 4 to select the function you wish to activate. Press XTRA again to go back to normal operation mode. Example of TV: 1 Keep SETUP pressed for 3 seconds: ­ the backlight (if enabled) turns on. the display shows ` ' , ` ' and 'TV?' ­ the keys that can be used are blinking. Use 3 and 4 to select 'DELETE TV' at the bottom of the list. If you miss certain functions from your original remote control on the SRU 5150, it can learn these functions from the original remote control. You can store a function under any of the available keys on the SRU 5150, except XTRA (LEARN) and SELECT (SETUP). Any function already stored under a key will be deleted. Make sure you have the original remote control at hand. Place both remote controls on a flat surface (like a coffee table) and aim them head-to-head with about 5 - 10 cm in between. Keep LEARN and the key you wish to learn on the SRU 5150 pressed simultaneously for 3 seconds, until ` ' lights up, together with 'LEARNING'. Press the key you wish to copy on the original remote control. When the remote control has learned the function, the display shows 'LEARN OK' to confirm that the signal is stored. If the display shows `ERROR` or `MEM FULL', start again from step 1. The backlight illuminates the display so you can clearly see all display messages, even in a dimly lit room. As the backlight consumes additional power, the battery lifetime will reduce when the backlight is used frequently. Keep digit keys 1 and 9 pressed simultaneously for three seconds. ­ The backlight function is now de-activated and the backlight cannot be turned on. Activating the backlight function Keep digit keys 7 and 9 pressed simultaneously for three seconds. [. . . ] The SRU 5150 can only learn IR signals with a carrier signal of 30-60kHz. ­ MEM FULL appears on the display while adding an extra (advanced) function or when trying to learn a key. No more functions can be added for the selected device or the SRU 5150 memory is full. Restore all the original functions of your remote control in order to create memory space. [. . . ]