User manual PHILIPS SWW1890

[. . . ] k Only use attachments/accessories specified by the manufacturer. l Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. 4 EN m Unplug this apparatus during lightning storms or when unused for long periods of time. n Refer all servicing to qualified service personnel. [. . . ] Make sure the video format is supported before the video is displayed, see the chapter on Technical data for information. If the picture on your TV is not full screen, see the chapter on `Frequently asked questions' for information. . · · · · · EN 11 English Establish the link between the transmitter and receiver LED indicator status of the receiver 6 Mount your receiver You can either mount the receiver on the wall or on the back of the HDTV. 5 Hook the key holes at the back of the receiver on the screws. Mount your receiver on the wall 1 2 3 4 Select a spot near the HDTV. Make sure that the distance between the two holes is 1 25/32" (45mm) and the diameter of the hole is 3/16" (5mm). Punch the supplied two anchors into the two holes on the wall. Put the two screws into the anchors and leave 1/8" (3mm) to mount the receiver on. 12 EN 1 2 Remove the white protective film from one of the supplied adhesive tapes. Secure the glued side of the adhesive tape and attach it to the central bottom area of the receiver. Note · The use of adhesive tapes is an alternative mounting · When you mount the receiver at the back of the · · option when the receiver cannot be fixed. HDTV, avoid blocking the ventilation holes of the HDTV. For safety reason, check regularly if the HDTV and receiver are mounted together firmly. The receiver is not recommended for in-the-wall installation. 3 4 5 Select a flat location on the rear side of the HDTV. Remove the white protective film from the other adhesive tape. Secure the glued side of the adhesive tape and attach it to the selected rear side of the HDTV. EN 13 English Mount your receiver on the back of the HDTV 6 Align the adhesive tape on the receiver with the one on the HDTV until both the receiver and HDTV are mounted together firmly. 7 Technical data Supported resolution Video format timings Resolution Operating frequencies: 5. 15-5. 25GHz / 5. 725-5. 825GHz Power supply: Input: AC 100~ 240V Output: DC 5V, 2A Operating temperature: 0~40°C/32~104°F Primary CEA video Timing 480p 480p 480p 576p 720p 720p 1080i 1080i 1080p/60 1080p/60 640x480p @ 59. 94/60Hz 720x480p @ 59. 94Hz 720x480p @ 60Hz 720x576p @ 50Hz 1280x720p @ 50Hz 1280x720p @ 59. 94/60Hz 1920x1080i @ 50Hz 1920x1080i @ 59. 94/60Hz 1920x1080p @50Hz 1920x1080p @ 59. 94/60Hz Transmitter interfaces A/V interfaces HDMI input: One (Type A, Male) Power interface Power input: The USB cable connected to the USB jack of the computer LEDs Status LED: 1 x blue LED Dimensions 30 x 83. 3 x 17. 5 mm (W x L x H) Receiver interfaces A/V interfaces HDMI output: One (Type A) Power interface Power input: 5V DC jack Switches Front power switch: One Info switch: One LEDs Power LED: 1 x LED (Two Tone: Blue & Red) Status LED: 1 x blue LED Signal quality status: On-screen display Dimensions 194. 8 x 146. 8 x 31 mm (W x L x H) Secondary CEA video Timing 1080p/24 1080p/24 1080p/24 1920x1080p @ 23. 98/24Hz 1920x1080p @ 25Hz 1920x1080p @ 29. 97/30Hz Product specifications General specification Video resolution HDMI input: 1080p, 1080i, 720p, 576p, 480p Supported audio formats: Digital audio: up to 6 Mbps AC3 and DTS Analog audio: 32-96 KHz and 16-24 bits per audio sample Transmission distance: Maximum 23 feet (7 meters). Antennas: High performance internal antennas 14 EN Notice for USA This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. · This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Recycling Incidental, special and consequential damages are disclaimed where permitted by law. This warranty gives you specific legal rights. You may also have other rights that vary from state to state. Your product is designed and manufactured with high quality materials and components, which can be recycled and reused. Never dispose of your product with other household waste. Please inform yourself about the local rules on the separate collection of electrical and electronic products. The correct disposal of your old product helps prevent potentially negative consequences on the environment and human health. [. . . ] Make sure that the resolution is comply to the supported resolution (See the chapter `Technical data', section supported resolution). On the computer screen, right click on your mouse. Make sure that the display 2 is on with or without enabling Extend the desktop onto this monitor. Make sure that the resolution is comply to the supported resolution (See the chapter `Technical data', section supported resolution). Tip For Windows Vista operating system: 1 2 3 For Windows XP operating system: 1 2 3 4 · For further information, click on Start > Help and Support, then enter `change display settings' on the blank space provided. 18 EN Note · If the MAC operation system does not detect the external display automatically, click · This product does not work with display port. on > Preference > Detect Displays. How can I change the audio setting of my computer to HDMI output? [. . . ]