User manual PHONIC POWERPOD408

[. . . ] This unit contains no user-serviceable parts. Refer all service needs to a qualified service engineer through a Phonic dealer. This triangle on your component alerts you to the presence of uninsulated " dangerous voltage" inside the enclosure that may be sufficient to constitute a risk of shock. This triangle on your component alerts you to important operating and maintenance instructions in this accompanying CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVERS (OR BACK). REFER ALL SERVICING TO A QUALIFIED SERVICE PERSONNEL. Keep this unit clean by using a soft dry brush and occasionally wiping it with a damp cloth. [. . . ] The control has a shelving response giving 15dB of boost or cut at 12kHz. 3 LEVEL CONTROL The Level Control determines the proportion of the channel signal in the mix, and provides a clear visual indication of channel level. 4 MIC & LINE INPUT The MIC input accepts XLR phone jack while the LINE input accepts a 1/4" type phone jack. Please use a low impedance microphone and a properly wired cable for best results. You can only use one of the two connectors at the same time. 5 EFFECT This knob decides the signal level which will be sent to the built-in digital delay effect control. Page 6 POWERPOD408 USER'S MANUAL PHONIC CORPORATION MASTER SECTION DESCRIPTION MASTER SECTION DESCRIPTION 6 DIGITAL DELAY The signal from the input channels, processed by the built-in digital delay will feed to the master output. There are three knobs here to control the effect of digital delay. LEVEL This knob adjusts the mix level of the effect sound. TIME This knob adjusts the internal time of the delays; turn to the right to increase the interval time between two delays. REPEAT To increase the rate of the delays, turn this knob to the right. You will hear the signal repeat at a faster rate. 7 POWER INDICATOR When the power switch at the rear panel is turned on , this indicator will illumnate so the user may be aware of it. 8 TAPE IN CONTROL This knob adjusts the level of signal from the Tape In to the Main bus. 9 MASTER CONTROL This adjusts the final level of the Main bus. It controls the Main bus signal which is output to the speakers. 10 TAPE IN AND REC OUT The TAPE IN sockets allow cassette recorders or CD players to be added to the Main output. The RECORD OUTPUT, with RCA phono sockets, provides signal output to a cassette deck and home audio equipment. The nominal output level and impedance are -10dBV/600ohms. PHONIC CORPORATION POWERPOD408 USER'S MANUAL Page 7 REAR PANEL DESCRIPTION REAR PANEL DESCRIPTION 11 POWER SWITCH This switches the powered mixer on and off. While turn it on, the power on blue LED indicator will light up on the master section of front panel. [. . . ] and Music Reinforcement Systems and Technology by Scott Hunter Stark. Mix Books, ISBN: 0918371074 Audiopro Home Recording Course Vol 1: A Com pre hen sive Mul ti me dia Audio Recording Text by Bill Gibson. Mix Books, ISBN: 0918371104 Audiopro Home Recording Course Vol. [. . . ]