User manual PIAGGIO X9 EVOLUTION

[. . . ] PIAGGIO WOULD LIKE TO THANK YOU for choosing one of its products. We have prepared this booklet to help you to get the very best from your scooter. Please read it carefully before riding the scooter for the first time. It contains information, tips and precautions for using your scooter. [. . . ] Proceed as follows in order to check the hub oil level: 1) Take the vehicle to a flat area and rest it on the support. 2) Unscrew the oil bar «A», dry it with a clean cloth and reinsert it, screwing it in completely. 3) Extract the bar and check that the oil level reaches the first notch from the bottom. 03_05 4) Screw the bar back in, checking that it is tightly in place. Recommended products AGIP ROTRA 80W-90 Rear hub oil SAE 80W/90 Oil that exceeds the requirements of API GL3 specifications Characteristic Rear hub oil (125) ~ 150 cc Rear hub oil (250) ~ 250 cc Tyres (03_07) Check periodically (about every 500 km) the tyre pressure. The tyres are equipped with wear indicators; the tyres should be replaced as soon as these indicators become visible on the tyre tread. Also check that the tyres do not show signs of splitting at the side or irregular tread wear; if this occurs, go to an authorised workshop or at least to a workshop equipped to perform the replacement. 3 bar Tyre pressure (rear wheel with rider and passenger) Rear wheel (rider and passenger) 2. 5 bar Spark plug dismantlement (03_08) Proceed as follows: 1. Remove the spark-plug access door, on the RHS fairing, and use your hand to reach out for the spark-plug; 2. detach the spark-plug cap , «A»; 3. Use the supplied box-spanner to loosen the spark-plug; 4. Refit the spark-plug by screwing it in by hand, with the correct inclination; 03_08 5. The box-spanner should only be used to tighten the spark-plug; 45 Downloaded from www. Carefully refit the spark-plug cap, «A». Com manuals search engine Removing the sides (03_09, 03_10, 03_11, 03_12, 03_13) Proceed as follows: 1. Loosen the two fixing screws «C» and then remove the seat lock cap; 2. Loosen the two fixing screws «D» and then remove the stop light support; 3. Undo the two upper screws «D» and the two lower unions with the side fairings. Undo the screw «A» on the fairing rear side; 03_09 5. Remove the screw «B» on the fairing lower side; 6. To remove the fairing, slide it towards the vehicle rear part so as to release the fixing tongues. [. . . ] Com manuals search engine 5 Spare parts and accessories 84 Downloaded from www. Com manuals search engine Scheduled maintenance table Adequate maintenance is fundamental to ensuring long-lasting, optimum operation and performance of your vehicle. To this end, a series of checks and maintenance operations (at the owner's expense) have been suggested, which are included in the summary table on the following page. Any minor faults should be reported without delay to an Authorised Service Centre or Dealer without waiting until the next scheduled service to solve it. [. . . ]