User manual PIONEER AVIC-9DVD-2 INSTALLATION MANUAL

[. . . ] ITALIANO NEDERLANDS 3 ENG/MASTER COVER 98 INST CRD3647A_inst_001_029_UK 4/15/02 2:03 PM Page 2 IMPORTANT INFORMATION ABOUT YOUR NEW DVD NAVIGATION UNIT AND THIS MANUAL • The Pioneer DVD Navigation Unit is intended solely as an aid to you in the operation of your vehicle. It is not a substitute for your attentiveness, judgement and care while driving. € Do not use your navigation system to route you to emergency services such as hospitals or police stations. Not all emergency service facilities are contained in the map data. [. . . ] Check the position of your vehicle’s reversing lamp (the one that lights up when the gearstick is in reverse [R]) and find the reversing lamp lead in the boot. 10 11 ENG/MASTER 96 CRD3647A_inst_001_029_UK 4/15/02 2:03 PM Page 12 Connecting the System Connecting the power cord (2) This product Note: Cords for this product and those for other products may be different colours even if they have the same function. When connecting this product to another product, refer to the supplied Installation manuals of both products and connect cords that have the same function. power cord Black To vehicle (metal) body. Be sure to install the unit in such a way that it will not obstruct driving. € Make sure that leads cannot get caught in a door or the sliding mechanism of a seat, resulting in a short circuit. € Please confirm the proper function of your vehicle’s other equipment following installation of the DVD navigation unit. ENGLISH ESPAÑOL DEUTSCH FRANÇAIS ITALIANO NEDERLANDS 12 ENG/MASTER 96 13 CRD3647A_inst_001_029_UK 4/15/02 2:03 PM Page 14 Installation To guard against electromagnetic interference • In order to prevent interference, set the following items as far as possible from the main unit of this Navigation System, other cables or leads: - TV aerial and aerial lead - FM, MW/LW aerial and its lead - GPS aerial and its lead In addition you should lay each aerial lead as far as possible from other aerial leads. Do not bind them together, lay them together, or cross them. Such electromagnetic noise would increase the error for the location display. Before installing and fixing • Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle. € Before finally installing the unit, connect the wiring temporarily, making sure it is all connected up properly, and the unit and the system work properly. Before using the adhesive tape • Make sure the surface is free of moisture, dust, grime, oil, etc. 13 ENG/MASTER 96 14 CRD3647A_inst_001_029_UK 4/15/02 2:03 PM Page 15 Installing the main unit ENGLISH Installation notes • Do not install the main unit in places where it may become subject to high temperatures or humidity, such as: * Places close to a heater outlet. * Places exposed to direct sunlight, such as on top of the dashboard or the rear shelf. * Places that may be splashed by rain, for example close to the door. € The installation strength will depend on the vehicle model and the installation position. Choose a position where the main unit can be firmly installed, and install it securely. If the main unit is not securely fastened, the errors in location display will be greater. € Do not install the main unit on the board covering the spare tyre or other places which are subject to vibration. € When the main unit is installed under a front seat, ensure that it does not obstruct the sliding action of the seat. € Do not install the main unit where it will be under luggage. [. . . ] NEDERLANDS 22 23 ENG/MASTER 96 CRD3647A_inst_001_029_UK 4/15/02 2:03 PM Page 24 Installation When installing with double-sided tape Attach the Holder using the double-sided tape (large) included in the set. When attaching horizontally Remote Control Holder Remove (not to be used) Double-sided tape (large) When attaching with elevated position Remote Control Holder Remove Double-sided tape (large) 23 ENG/MASTER 96 24 CRD3647A_inst_001_029_UK 4/15/02 2:03 PM Page 25 Installing the microphone ENGLISH Installation notes • Install the microphone in a position and orientation that will enable it to pick up the voice of the person operating the system. parts supplied ESPAÑOL DEUTSCH Microphone Microphone clip Double-sided tape (small) Clamp (5 pcs. ) FRANÇAIS ITALIANO NEDERLANDS 24 ENG/MASTER 96 25 CRD3647A_inst_001_029_UK 4/15/02 2:03 PM Page 26 Installation When installing the microphone on the sun visor 1. [. . . ]