User manual PIONEER AVICC-C-HD3-2

[. . . ] This manual explains how to install this navigation system in your vehicle. operation of this navigation system is explained in the separate operation manual or hardware manual for the navigation system. Before operating this navigation system, be sure to read them. Do not attempt to install or service your navigation system by yourself. [. . . ] Speed detection circuit lead Vehicle injection Connector computer The mobile navigation system is connected here to detect the distance the vehicle travels. Always connect the vehicle's speed detection circuit or the ND-PG1 speed pulse generator, sold separately. Connection method Pass the extension cord and the lead for the speed detection circuit through this hole. It is strongly suggested that the speed pulse wire be connected for accuracy of navigation and better performance of interlock. If the speed pulse wire is unavailable for some reason, it is recommended that the pulse generator (ND-PG1) be used. This lead must be connected to the power supply side of the handbrake switch. If this connection is made incorrectly or omitted, certain functions of your navigation system will be unusable. Extension lead (for speed signal) This is connected so that the navigation system can detect whether the vehicle is moving forwards or backwards. Connect the violet/white lead to the lead whose voltage changes when the reverse gear is engaged. Unless connected, the sensor may not detect your vehicle travelling forward/backward properly, and thus the position of your vehicle detected by the sensor may be misaligned from the actual position. Note: When you use the ND-PG1 speed pulse generator (sold separately), please make sure to connect this lead. When you use a rear view camera, please make sure to connect this lead. Otherwise you cannot switch to rear view camera picture. When combining this navigation system with the other Pioneer audio unit for the vehicle, if the vehicle stereo has yellow/black leads, connect them to those leads. in this way , the vehicle stereo is automatically muted to reduce the vehicle stereo volume when; ­ the guidance audio is output. ­ the mobile phone is used via Bluetooth unit. Be sure to use only the supplied extension lead. Use of another lead could cause fire, smoke and/or damage this navigation system. Check the position of your vehicle's reversing lamp (the one that lights up when the gearstick is in reverse [R]) and find the reversing lamp lead in the boot. When connecting to separately sold power amp Front output (FRONT OUTPUT) The navigation unit 15 cm 15 cm Blue/white To system control terminal of the power amp (max. Do not connect this lead to Auto-aerial control terminal. Perform these connections when using the optional amplifier. [. . . ] If it is left on the outside it may be knocked off and scratch the vehicle body. Do not paint the GPS aerial, as this may affect its performance. When installing the aerial inside the vehicle (on the rear shelf) español Affix the metal sheet on as level a surface as possible where the GPS aerial faces the window. Make sure the surface is free of moisture, dust, grime, oil, etc. [. . . ]