User manual PIONEER CB-F130

[. . . ] In some countries or regions, the shape of the power plug and power outlet may sometimes differ from that shown in the explanatory drawings. However the method of connecting and operating the unit is the same. RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified service personnel. [. . . ] When a new Cue Point is set, the previously set Cue Point is deleted. Press the [FX 1] button: TRAKTOR effect unit [FX 1] is assigned to the deck whose button is pressed. Press the [FX 2] button: TRAKTOR effect unit [FX 2] is assigned to the deck whose button is pressed. * When using TRAKTOR SCRATCH DUO 2 , the assignment is fixed: [FX 1] to deck [A] , [FX 2] to deck [B]. If you upgrade to TRAKTOR SCRATCH PRO 2, [FX 1] and [FX 2] can be assigned freely to the desired deck. Press: The [BPM] and [Beat Grid] of the track for the deck whose button was pressed are synchronized to the master for synchronization. [SHIFT] + press: The deck whose button was pressed is set as the master for synchronization. Synchronizing the playing speed with other decks (beat sync) 1 Press the [SYNC (MASTER)] button while pressing the [SHIFT] button on the currently playing deck. The deck whose button was pressed is set as the master for synchronization. 2 Press the [SYNC (MASTER)] button on the deck not set as the master for synchronization. The [BPM] and [Beat Grid] of the track for the deck not set as the master for synchronization are synchronized to the [BPM] and [Beat Grid] of the track for the deck set to the master for synchronization. The sound of the respective channels is output according to the curve characteristics selected with the [CROSS F. Displays the sound level of the respective channels before passing through the channel faders. Displays the audio level output from the [MASTER1] and [MASTER2] terminals. Audio signals are output from the [MASTER1] and [MASTER2] terminals. Adjusts the monitor volume balance between the sound of the channel whose [CUE (TAP)] button is pressed and the [MASTER] channel sound. Refer to Specifications on page 30 for the range of sound that can be adjusted by each control. Adjusts the audio level output from the [PHONES] terminal. This can be used to adjust the crossfader's operating load. Adjusts the monitor volume balance between the sound of the channel whose [CUE (TAP)] button is pressed and the [MASTER] channel sound. To monitor only the sound of the [MASTER] channel, turn the [HEADPHONES MIXING] control clockwise from the center position. The sound of the channel whose [CUE (TAP)] button is pressed and the sound of the [MASTER] channel are mixed and output from the headphones. [. . . ] The [Single] mode cannot be selected with TRAKTOR SCRATCH DUO 2. If you upgrade to TRAKTOR SCRATCH PRO 2, the effect panel can be switched to the [Single] mode. (page 24) To operate DJ software with this unit, this unit's MIDI messages must be assigned to the DJ software you are using. If it is already installed, uninstall it then reinstall it. [. . . ]