User manual PIONEER CDJ-800 MK2 UPDATE INSTRUCTIONS

[. . . ] CDJ-800MK2 UPDATE INSTRUCTIONS Applicable Model : CDJ-800MK2 Confirm Current Firmware Version 1. Hold the "RELOOP/EXIT" button for about 10 seconds to display the firmware version on the display. [. . . ] Improved Loop Control This update improves jumpiness after releasing a certain loop control in some specific conditions. Enhanced Disc Detection Ability This update enhances the detection ability for CD-ROM and CD-DA disc. Download the Firmware 1. Download the firmware ZIP file from Pioneer's website to a folder on your computer. Unzip the file and save it to a folder on your computer. After unzipping, you will have 1 file that will need to be burned to CD-R/RW. Check the firmware file Check the file name and size by right clicking on the file and choosing "Properties". Name 800MK2. HEX Size 1. 93 MB (2, 027, 720 bytes) Date 3/10/2008 * Download again if the file name and size do not match the ones listed above. Create the Update Disc Copy/burn the file "800MK2. HEX" to a blank CD-R or CD-RW disc. Note) - Use a good quality branded blank CD-R disc or completely erased CD- RW disc. - Burn the firmware file into the disc using disc-at-once mode (2x Speed) - Make sure that the disc session is closed / the disc is finalized. * If the correct file is not copied to the disc, your player will not recognize it as an update disc and you will not be able to carry out the update. Update Your Player Perform the following procedure to update the firmware. [. . . ] After completing the update, the disc is automatically ejected and message "COMPLETE" appears on the display. Turn on the power and confirm the firmware version. Note) If you have any difficulty carrying out these instructions, please contact Pioneer Customer Support Center. - If "ERROR" appears on the display, turn off the power, and then please contact Pioneer Customer Support Center. [. . . ]