User manual PIONEER CLD-1200 annexe 1

[. . . ] The surfaces of the amplifier and any attached speakers may also heat up and cause minor burns. Thank you for purchasing this PIONEER product. To ensure proper use, please read through this manual before using this product. It is especially important that you read and observe WARNINGs and CAUTIONs in this manual. [. . . ] Always keep the volume low enough to hear outside sounds. Extended use of the car stereo while the engine is at rest or idling may exhaust the battery. If the Protection function is turned on, the power indicator will turn off, and the amplifier will shut down. If the temperature inside the amplifier gets too high. Setting the unit What's what Protective function included to prevent malfunction of the unit and/or speakers due to excessive output, improper use or improper connection. , this function cuts off the output for a few seconds as a normal function, but output is restored when the volume of the head unit is turned down. A cut in sound output may indicate improper setting of the gain control. To ensure continuous sound output with the head unit at a high volume, set amplifier gain control to a level appropriate for the preout maximum output level of the head unit, so that volume can remain unchanged and to control excess output. Despite correct volume and gain settings, the unit sound still cuts out periodically. This eliminates high range frequency and outputs low range frequency. 2 GAIN (gain) control If output remains low, even when the car stereo volume is turned up, turn controls to lower level. For any further enquiries, contact your local authorized Pioneer dealer or customer service. Connect the speaker leads to suit the mode according to the figures shown below. Ensure speakers conform to the following standards, otherwise there is a risk of fire, smoke or damage. Do not connect both the RCA input and the speaker input at the same time. The use of a special red battery and ground wire RD-223, available separately, is recommended. If the battery wire is not securely fixed to the terminal using the terminal screws, there is a risk of overheating, malfunction and injury, including minor burns. After completing all other amplifier connections, finally connect the battery wire terminal Fix the wires securely with the terminal screws. Fix the speaker wires securely with the terminal screws. 1 Use wire cutters or a utility knife to strip the end of the speaker wires to expose about 10 mm of wire and then twist the wire. To ensure proper installation, use the supplied parts in the manner specified. If any parts other than those supplied are used, they may damage internal parts of the amplifier, or become loose causing the amplifier to shut down. [. . . ] After installing the amplifier, confirm that the spare tire, jack and tools can be easily removed. Example of installation on the floor mat or chassis 1 Place the amplifier in the desired installation location. Insert the supplied tapping screws (4 mm × 18 mm) into the screw holes and push on the screws with a screwdriver so they make an imprint where the installation holes are to be located. 3 Install the amplifier with the use of supplied tapping screws (4 mm × 18 mm). [. . . ]