User manual PIONEER CP-ST100

[. . . ] These stands have been designed to allow the mounting of up to three speakers each, but the number actually mounted will depend on the speaker system used (surround setting). When assembling the stands, use only that number of support arms actually required for the speakers to be mounted. For more information regarding various surround setups, consult the owners manuals furnished with your speakers and home theater system. [. . . ] 3 Place a support (long) over the mounting post in the stand base, and fasten securely with two countersunk screws (M4xL6). The screw holes in the stand base are oriented to the rear side. The support (long) is designed with specific up-down orientation. Peel the protective paper backing from the clip and affix the clip to the indentation on the underside of the arm as shown. Peel the protective paper backing from the gasket and affix the gasket to the angle bracket as shown. Be sure to confirm the direction of the gasket so as to properly align the gasket's hole with the screw hole in the angle bracket. 4 Lay the stand on its side, and pass the speaker wires into the hole in the stand base and through the support. Consult the owner's manual for the speaker system and confirm the proper wires to be used (wires may be color coded). 5 Assemble the arm and support (short) and pass each speaker wire through in order as shown. The arms are designed with specific up-down orientation; confirm that the side with the wire clip is oriented downward during assembly. Pass the appropriate speaker wire through each arm and mount the assembled arms in order on the long support. In the case of the speaker wire for the lowest arm, do not pass the wire through the arm, but allow the wire to exit the cutaway portion of the arm as shown, then affix a cap to the top of the arm. Assemble the stands so that the screw holes in the supports are all oriented toward the rear side of the stand, then insert the furnished countersunk screws and tighten securely. Do not attempt to insert screws when the supports holes are oriented at a diagonal angle from the rear of the stand. [. . . ] If necessary, clean with a cloth dipped in a neutral cleanser diluted five or six times with water, and wrung out well. Never use alcohol, thinners, benzine, insecticide sprays or other chemicals on or near this unit since these will corrode the surfaces. When using chemically-treated cloths, be sure to carefully read their accompanying instruction manual. [. . . ]