User manual PIONEER CT-S707

[. . . ] This equipment complies with FCC/IC radiation exposure limits set forth for uncontrolled equipment and meets the FCC/IC radio frequency (RF) Exposure Guidelines in Supplement C to OET65 and RSS-102 of the IC radio frequency (RF) exposure rules. This equipment has very low levels of RF energy that it is deemed to comply without testing of specific absorption ratio (SAR). 01 Before You Start For Canadian model This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] 3 Press MULTI-CONTROL to turn automatic answering on. # To turn automatic answering function off, press MULTI-CONTROL again. Operating this unit 5 DATA TRANSFERRED is displayed and phone book transfer is completed. Echo canceling and noise reduction Setting the automatic connection It is possible to set the automatic connection between your cellular phone and this unit. If this function is set to on, connection between your cellular phone and this unit will take place automatically as soon as the two devices are less than a few meters apart. With some cellular phones, it may not be possible to perform the automatic connection. Refer to Introduction to advanced operations on page 39. 2 Use MULTI-CONTROL to select AUTO CONNECT. 3 Press MULTI-CONTROL to turn automatic connection on. # To turn automatic connection off, press MULTI-CONTROL again. Note Automatic connection is performed in the registration number order. 1 Display the function menu. Refer to Introduction to advanced operations on page 39. 2 Use MULTI-CONTROL to select ECHO CANCEL. 3 Push MULTI-CONTROL left or right to select the desired setting. OFF (off)--LOW--MID--HIGH # This function can be performed even while talking on the phone. ENGLISH (English)--PYCCKOE (Russian)-- ESPANOL (Spanish) 02 En 43 Operating this unit Section 03 Audio Adjustments Introduction of audio adjustments Using balance adjustment You can change the fader/balance setting so that it can provide the ideal listening environment in all occupied seats. Refer to Introduction of audio adjustments on this page. 1 Audio display Shows the audio adjustment status. 2 Use MULTI-CONTROL to select FADER/BALANCE. 3 Push MULTI-CONTROL up or down to adjust front/rear speaker balance. Each time MULTI-CONTROL is pushed up or down, the front/rear speaker balance moves towards the front or rear. F 15 to R 15 is displayed as the front/rear speaker balance moves from front to rear. # 0 is the proper setting when only two speakers are used. # When the rear output setting is REAR SP :S/W, you cannot adjust front/rear speaker balance. Refer to Setting the rear output and subwoofer controller on page 49. 1 Press MULTI-CONTROL to display the main menu. 3 Turn MULTI-CONTROL to select the audio function. Turn MULTI-CONTROL to switch between the audio functions in the following order. FADER/BALANCE (balance adjustment)-- EQUALIZER (graphic equalizer adjustment)-- G. EQ ADJUST (7-band graphic equalizer adjustment)--LOUDNESS (loudness)--SUB W1 (subwoofer on/off setting)--SUB W2 (subwoofer setting)--BASS BOOST (bass boost)-- HIGH PASS FILTER (high pass filter)--SLA (source level adjustment) # You can also select the audio function by pressing AUDIO on the remote control. # You can select the SUB W2 only when subwoofer output is turned on in SUB W1. [. . . ] ­18 dB/oct Gain . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +6 dB to ­24 dB Phase . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Normal/Reverse Bass boost: Gain . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +12 dB to 0 dB FM tuner Frequency range . . . . . . . . . . . . . . . . . . . . . . [. . . ]