User manual PIONEER CT-X5

[. . . ] Make sure it is properly disposed of after removal. The equipment should be disconnected by removing the mains plug from the wall socket when left unused for a long period of time (for example, when D3-4-2-2-1a_A_En on vacation). CAUTION The POWER switch on this unit will not completely shut off all power from the AC outlet. Since the power cord serves as the main disconnect device for the unit, you will need to unplug it from the AC outlet to shut down all power. [. . . ] How to replace the fuse: Open the fuse compartment with a screwdriver and replace the fuse. 7 150 W power that serves video software playback such as Dolby* Digital with a wide dynamic range. 7 Equipped with 22 cm driver 7 Crossover frequency can be continuous (50 Hz to 200 Hz). The frequency characteristics of the S-W160S combined with small-size speakers are shown below. As shown in these figures, the low frequency range is improved. These special characteristics are obtained in an echoless chamber. The effect of an additional S-W160S in an ordinary listening room is better than the chart indicates when positioned adequately. With playback of Dolby* Digital, establishment of a special channel for the subwoofer is recommended; and with playback of LFE (Low Frequency Effect: sound effect like the rumbling of the earth, whose purpose is to intensify the force of the video), the S-W160S is especially effective. This is because it has 5 channels in the 20Hz to 20kHz frequency range (front left and right, center, and rear left and right) and an independent channel for the subwoofer. The subwoofer plays back the bass in monaural, making use of the fact that the human ear loses the sense of direction of lowpitched sound. Since the sense of direction is lost, the subwoofer can be installed almost anywhere. When pressed, power is turned ON; when pressed again, power is turned OFF. Turn the knob slowly from the MIN position. With this unit, the bass level can be independently set, so do not turn up the bass on the stereo amplifier. When depressed (_ 180°), the output phase becomes the reverse of the input signal, and when raised (-- 0° ), it is in the same phase as the input signal. But when the sound connection between the subwoofer and the left and right speakers sounds unnatural, try switching to 180° and set the switch in the position where the sound is natural. When set to DIRECT, the audio signal is routed directly to the woofer unit, by passing the amplifer's filter. Before making or changing the connections, switch off the power switch and disconnect the power cord from the AC outlet. This connection is for the amplifier or receiver equipped with a SUBWOOFER PRE-OUT terminal. Connect to the LINE LEVEL INPUT terminal on this unit, using the specially provided RCA plug cord. nOTES: ÷ When connected to the PRE-OUT terminal for surround center channel on the amplifier or receiver, the bass is heard only on the center channel, so it will be insufficient. Adjust the strength of the bass with the VOLUME knob 3. [. . . ] Power supply to amplifier or speaker switch is turned off. The AM loop antenna or the FM indoor antenna is close to this unit. Do not pull out the plug by tugging the cord and never touch the power cord when your hands are wet as this could cause a short circuit or electric shock. Do not place the unit, a piece of furniture, etc. [. . . ]