User manual PIONEER CU-AV100

[. . . ] Operating environment temperature and humidity: +5 °C to +35 °C (+41 °F to +95 °F); less than 85 %RH (cooling vents not blocked) Do not install this unit in a poorly ventilated area, or in locations exposed to high humidity or direct sunlight (or D3-4-2-1-7c*_A1_En strong artificial light) If the AC plug of this unit does not match the AC outlet you want to use, the plug must be removed and appropriate one fitted. Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified service personnel. if connected to an AC outlet , the cut-off plug can cause severe electrical shock. Make sure it is properly disposed of after removal. [. . . ] Avoid using remotes for other components located close to this unit. 1 Noise may be generated when receiving AM, FM, or DAB broadcasting if a near-by television set is turned on. The tuner should be used as far away from a television as possible. 2 Effective period of memory back-up is about a month under normal temperature. 8 MPX Use to switch between stereo and mono reception during FM broadcasts. If the signal is weak, switching to mono may improve the sound quality (page 15). TUNE When pressed during FM or AM mode, receivable stations are automatically stored in the preset memory in order starting from preset channel A1. Hold the button depressed for two seconds or longer during DAB mode to perform full scan operation (Full band and L-band). Press the button briefly during DAB mode to perform a local scan (UK band III) for UK broadcast services (UK stations are in the range of 11B to 12D). This button is also used for manual station-name character selection for FM and AM broadcasts, and for Program Type search. 3 Station call buttons (1 to 10) Use these buttons to preset stations, and to recall previously preset stations. 6 If you want to continue listening to the station, press the TUNING/PRESET dial or ENTER button within five seconds. if you don't press the TUNING/PRESET knob or ENTER button , searching resumes. If the program type cannot be found, the unit will automatically begin the frequency search mode. ALARM is used for emergency broadcast announcements. You cannot search for this type of announcement, but the tuner will switch automatically to this RDS signal in the event of a broadcast. If no stations have been preset, or if the PTY search could not be found among the station presets NO PTY DATA is displayed. Use the DISPLAY button to display the different types of RDS information available. Each press changes the display as follows: · radio Text (RT) ­ Messages sent by the radio station. For example, a talk radio station may provide a phone number as RT. Choose from the following characters for a name up to eight characters long. If no character is input, a space is input. [. . . ] Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component, check the points below. Sometimes the trouble may lie in another component. Investigate the other components and electrical appliances being used. [. . . ]